Measurement of deformations at forming by method of embossed defrmation networks and their evaluation

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F61989100%3A27230%2F01%3A00000023" target="_blank" >RIV/61989100:27230/01:00000023 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Measurement of deformations at forming by method of embossed defrmation networks and their evaluation

Popis výsledku v původním jazyce

The contribution concerns the method of deformation networks in range of stampings drawing from sheet-metal. For objective evaluation of stress and strain by deformation networks the separate elements of deformation network on stampings must be preciselymeasured. With regard to the fact, that the elements appears also on round and curved surfaces, its accurate measurement is difficult. In contribution the special gauge for measurement of lengths on curved surfaces, which was constructed by the author,is fully described. By the use of this gauge it is possible to measure the lengths on curved surfaces with accuracy of 0.01 mm. The advantages of the gauge are low material costs, small mass, accuracy and simple operation. The gauge is easy to manufacture and it is universal.

Název v anglickém jazyce

Measurement of deformations at forming by method of embossed defrmation networks and their evaluation

Popis výsledku anglicky

The contribution concerns the method of deformation networks in range of stampings drawing from sheet-metal. For objective evaluation of stress and strain by deformation networks the separate elements of deformation network on stampings must be preciselymeasured. With regard to the fact, that the elements appears also on round and curved surfaces, its accurate measurement is difficult. In contribution the special gauge for measurement of lengths on curved surfaces, which was constructed by the author,is fully described. By the use of this gauge it is possible to measure the lengths on curved surfaces with accuracy of 0.01 mm. The advantages of the gauge are low material costs, small mass, accuracy and simple operation. The gauge is easy to manufacture and it is universal.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JG - Hutnictví, kovové materiály

OECD FORD obor

—

Projekt

<a href="/cs/project/GA101%2F00%2F0488" target="_blank" >GA101/00/0488: Rozpracování metodiky stanovení tvaru a velikosti přístřihu pro tažení dutých výtažků nepravidelných tvarů z tenkých plechů</a><br>

Návaznosti

P - Projekt vyzkumu a vyvoje financovany z verejnych zdroju (s odkazem do CEP)<br>Z - Vyzkumny zamer (s odkazem do CEZ)

Rok uplatnění

2001

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufactoring Technology

ISSN

1213-2489

e-ISSN

—

Svazek periodika

6

Číslo periodika v rámci svazku

4

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

9

Strana od-do

8-16

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—