Spring-back analysis of stamping final shape in the Autoform 4.06 and PAM-STAMP 2G programmes and comparison with dimensions specified at part production drawing.

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F61989100%3A27230%2F10%3A10224844" target="_blank" >RIV/61989100:27230/10:10224844 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Spring-back analysis of stamping final shape in the Autoform 4.06 and PAM-STAMP 2G programmes and comparison with dimensions specified at part production drawing.

Popis výsledku v původním jazyce

The contribution concerns the drawing process simulation of intricate asymmetric shape stamping from thin sheet-metal - inside reinforcement of the car front door, with aiming at spring-back evaluation of this stamping after drawing operation. The evaluation of simulations results with the use of AutoForm 4.06 and PAM-STAMP 2G programmes is carried out - the evaluation of utilization of the material plasticity stock and risk of stamping crack at drawing, the sheet-metal thinning at drawing, the wrinkling of the stamping at forming. Then the procedure of spring-back simulation after stamping drawing is described. The results got by simulations in both programmes are compared partly to each other, partly with dimensions of real stamping got by drawing and consequently by 3D measurement of stamping.

Název v anglickém jazyce

Spring-back analysis of stamping final shape in the Autoform 4.06 and PAM-STAMP 2G programmes and comparison with dimensions specified at part production drawing.

Popis výsledku anglicky

The contribution concerns the drawing process simulation of intricate asymmetric shape stamping from thin sheet-metal - inside reinforcement of the car front door, with aiming at spring-back evaluation of this stamping after drawing operation. The evaluation of simulations results with the use of AutoForm 4.06 and PAM-STAMP 2G programmes is carried out - the evaluation of utilization of the material plasticity stock and risk of stamping crack at drawing, the sheet-metal thinning at drawing, the wrinkling of the stamping at forming. Then the procedure of spring-back simulation after stamping drawing is described. The results got by simulations in both programmes are compared partly to each other, partly with dimensions of real stamping got by drawing and consequently by 3D measurement of stamping.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JR - Ostatní strojírenství

OECD FORD obor

—

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2010

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Sborník vědeckých prací Vysoké školy báňské - Technické univerzity Ostrava. Řada strojní

ISSN

1210-0471

e-ISSN

—

Svazek periodika

56

Číslo periodika v rámci svazku

2

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

12

Strana od-do

31-42

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—