Effect of increasing feed speed on the machined surface integrity

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F61989100%3A27230%2F11%3A86079711" target="_blank" >RIV/61989100:27230/11:86079711 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Effect of increasing feed speed on the machined surface integrity

Popis výsledku v původním jazyce

Paper describes the issue of high speed milling. There is describe an experiment, it was performed on high speed machining center at the Technical university of Poznan and thanks to CEEPUS program. At the experiment were used material ASP 2023 (tool steel) and two different cutters. First tool had three edges and the other had four edges. Diameter of both millers was the same. These tools have been performed several cuts, and there were gradually increased feed speed and cutting speed. These individualsections were consequently investigated. There were measured surface roughness and residual stress. At the roughness was measured roughness Ra and Rz. To determine the residual stress mas used method of Barkhausen noise.

Název v anglickém jazyce

Effect of increasing feed speed on the machined surface integrity

Popis výsledku anglicky

Paper describes the issue of high speed milling. There is describe an experiment, it was performed on high speed machining center at the Technical university of Poznan and thanks to CEEPUS program. At the experiment were used material ASP 2023 (tool steel) and two different cutters. First tool had three edges and the other had four edges. Diameter of both millers was the same. These tools have been performed several cuts, and there were gradually increased feed speed and cutting speed. These individualsections were consequently investigated. There were measured surface roughness and residual stress. At the roughness was measured roughness Ra and Rz. To determine the residual stress mas used method of Barkhausen noise.

Druh

D - Stať ve sborníku

CEP obor

JR - Ostatní strojírenství

OECD FORD obor

—

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2011

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

Annals of DAAAM & Proceedings of DAAAM International Symposium

ISBN

978-3-901509-83-4

ISSN

—

e-ISSN

—

Počet stran výsledku

4

Strana od-do

1039-1040

Název nakladatele

DAAAM International Vienna

Místo vydání

Vídeň

Místo konání akce

Vienna

Datum konání akce

23. 11. 2011

Typ akce podle státní příslušnosti

WRD - Celosvětová akce

Kód UT WoS článku

—