Cutting forces by turning of Inconel 718 with inserts from different materials

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F61989100%3A27230%2F13%3A86087844" target="_blank" >RIV/61989100:27230/13:86087844 - isvavai.cz</a>

Výsledek na webu

<a href="http://www.scopus.cz" target="_blank" >http://www.scopus.cz</a>

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Cutting forces by turning of Inconel 718 with inserts from different materials

Popis výsledku v původním jazyce

This paper presents achieved results by measuring of force load tool by turning of nickel alloy Inconel 718 with sintered carbide with progressive chip breaker designed by Pramet Tools Ltd. Company and with cutting ceramics inserts produced by GreenleafCompany. Authors deal with studying of force load which is exposed the cutting tool by conditions, when are achieved limit val-ues in view of tool wear. In the end it is carried out a comparison of intensity of components of cutting force for these limitconditions. Very interesting is finding that by machining with worst cutting conditions the force load on insert cutting edge is smaller than by machining with best cutting parameters. This fact can be reasoned by the fact that at higher cutting conditions we are getting into the area of HSC machining for Inconel 718 and therefore the cutting forces are smaller. There is more heat produced in cutting zone. This influence undesirably sintered carbide during cutting process. Vice versa, h

Název v anglickém jazyce

Cutting forces by turning of Inconel 718 with inserts from different materials

Popis výsledku anglicky

This paper presents achieved results by measuring of force load tool by turning of nickel alloy Inconel 718 with sintered carbide with progressive chip breaker designed by Pramet Tools Ltd. Company and with cutting ceramics inserts produced by GreenleafCompany. Authors deal with studying of force load which is exposed the cutting tool by conditions, when are achieved limit val-ues in view of tool wear. In the end it is carried out a comparison of intensity of components of cutting force for these limitconditions. Very interesting is finding that by machining with worst cutting conditions the force load on insert cutting edge is smaller than by machining with best cutting parameters. This fact can be reasoned by the fact that at higher cutting conditions we are getting into the area of HSC machining for Inconel 718 and therefore the cutting forces are smaller. There is more heat produced in cutting zone. This influence undesirably sintered carbide during cutting process. Vice versa, h

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JQ - Strojní zařízení a nástroje

OECD FORD obor

—

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2013

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufactoring Technology

ISSN

1213-2489

e-ISSN

—

Svazek periodika

13

Číslo periodika v rámci svazku

4

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

5

Strana od-do

499-504

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—