CNC Milling and Manufacturing of Groove Shapes for Light Reflection Measurement

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F61989100%3A27230%2F14%3A86091768" target="_blank" >RIV/61989100:27230/14:86091768 - isvavai.cz</a>

Nalezeny alternativní kódy

RIV/70883521:28110/14:43872843

Výsledek na webu

<a href="http://journal.strojirenskatechnologie.cz/templates/obalky_casopis/XIV_2014-4.pdf" target="_blank" >http://journal.strojirenskatechnologie.cz/templates/obalky_casopis/XIV_2014-4.pdf</a>

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

CNC Milling and Manufacturing of Groove Shapes for Light Reflection Measurement

Popis výsledku v původním jazyce

Light reflection of materials depends on many factors, mainly on their colour and type, angle of light incidence and surface structure. This paper is focused on evaluation of the surface shape influence of expanded polyvinylchloride on light reflection.For this reason polyvinylchloride samples with different shapes, depths, widths and numbers of surface grooves were produced on CNC milling machine. The light reflection of the investigated material samples was experimentally measured by means of illuminance ratio. The samples were subsequently compared in terms of their ability to reflect light. A part of the work deals with mathematical simulation of the daylight factor for definite surface shapes. The simulations were performed using Wdls 4.1 software. It was found that the surface shape has an influence on the light reflection and on the illuminance in a given point too. The light reflection of the tested material is in general influenced by shape, depth, width and number of surface

Název v anglickém jazyce

CNC Milling and Manufacturing of Groove Shapes for Light Reflection Measurement

Popis výsledku anglicky

Light reflection of materials depends on many factors, mainly on their colour and type, angle of light incidence and surface structure. This paper is focused on evaluation of the surface shape influence of expanded polyvinylchloride on light reflection.For this reason polyvinylchloride samples with different shapes, depths, widths and numbers of surface grooves were produced on CNC milling machine. The light reflection of the investigated material samples was experimentally measured by means of illuminance ratio. The samples were subsequently compared in terms of their ability to reflect light. A part of the work deals with mathematical simulation of the daylight factor for definite surface shapes. The simulations were performed using Wdls 4.1 software. It was found that the surface shape has an influence on the light reflection and on the illuminance in a given point too. The light reflection of the tested material is in general influenced by shape, depth, width and number of surface

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JR - Ostatní strojírenství

OECD FORD obor

—

Projekt

—

Návaznosti

V - Vyzkumna aktivita podporovana z jinych verejnych zdroju

Rok uplatnění

2014

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufacturing Technology

ISSN

1213-2489

e-ISSN

—

Svazek periodika

14

Číslo periodika v rámci svazku

4

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

7

Strana od-do

516-522

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—