Cutting forces during turning with variable depth of cut

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F61989100%3A27230%2F16%3A86094490" target="_blank" >RIV/61989100:27230/16:86094490 - isvavai.cz</a>

Výsledek na webu

<a href="http://www.346.vsb.cz/" target="_blank" >http://www.346.vsb.cz/</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.1016/j.pisc.2015.11.055" target="_blank" >10.1016/j.pisc.2015.11.055</a>

Jazyk výsledku

angličtina

Název v původním jazyce

Cutting forces during turning with variable depth of cut

Popis výsledku v původním jazyce

The purpose of this paper is to investigate the problems with increasing the efficiency of turning cycles. This paper also describes and suggests the possibility of using effective strategies and their application in programming CNC turning centers. It proposes new roughing turning cycles where variable depth of cut is applied. Suggested roughing cycles with the use of variable depth of cut will ensure increasing the durability of the cutting tool and the efficiency during turning. The proposed research for the paper is an experimental work - measuring cutting forces and monitoring of the tool wear on the cutting edge. It compares the turning where standard roughing cycle is used and the turning where the proposed roughing cycle with variable depth of cut is applied.

Název v anglickém jazyce

Cutting forces during turning with variable depth of cut

Popis výsledku anglicky

The purpose of this paper is to investigate the problems with increasing the efficiency of turning cycles. This paper also describes and suggests the possibility of using effective strategies and their application in programming CNC turning centers. It proposes new roughing turning cycles where variable depth of cut is applied. Suggested roughing cycles with the use of variable depth of cut will ensure increasing the durability of the cutting tool and the efficiency during turning. The proposed research for the paper is an experimental work - measuring cutting forces and monitoring of the tool wear on the cutting edge. It compares the turning where standard roughing cycle is used and the turning where the proposed roughing cycle with variable depth of cut is applied.

Druh

J_ost - Ostatní články v recenzovaných periodicích

CEP obor

—

OECD FORD obor

20301 - Mechanical engineering

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2016

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Perspectives in Science

ISSN

2213-0209

e-ISSN

—

Svazek periodika

2016

Číslo periodika v rámci svazku

7

Stát vydavatele periodika

NL - Nizozemsko

Počet stran výsledku

7

Strana od-do

357-363

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—