Square Shaped Insert´s Lifetime when Milling Inconel 718

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F61989100%3A27230%2F17%3A10236578" target="_blank" >RIV/61989100:27230/17:10236578 - isvavai.cz</a>

Výsledek na webu

<a href="http://www.mmscience.eu/201760" target="_blank" >http://www.mmscience.eu/201760</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.17973/MMSJ.2017_12_201760" target="_blank" >10.17973/MMSJ.2017_12_201760</a>

Jazyk výsledku

angličtina

Název v původním jazyce

Square Shaped Insert´s Lifetime when Milling Inconel 718

Popis výsledku v původním jazyce

This article is focused on the analysis of tool wear in milling of Inconel 718. Inconel 718 is tough and highly temperature resistive materiál, which is used due to its excellent properties especially in agressive corrosive environment. Machining of this alloy is still complicated. The feasibility of three inserts tested for milling of Inconel 718 has been shown in this work. Different cutting speeds and feeds were used. Experimental tests were performed in order to analyze wear evolution. It was found that cutting conditions and type of insert strongly affects tool wear mode. Surface roughness was studied as well as cutting force as a function of tool wear.

Název v anglickém jazyce

Square Shaped Insert´s Lifetime when Milling Inconel 718

Popis výsledku anglicky

This article is focused on the analysis of tool wear in milling of Inconel 718. Inconel 718 is tough and highly temperature resistive materiál, which is used due to its excellent properties especially in agressive corrosive environment. Machining of this alloy is still complicated. The feasibility of three inserts tested for milling of Inconel 718 has been shown in this work. Different cutting speeds and feeds were used. Experimental tests were performed in order to analyze wear evolution. It was found that cutting conditions and type of insert strongly affects tool wear mode. Surface roughness was studied as well as cutting force as a function of tool wear.

Druh

J_SC - Článek v periodiku v databázi SCOPUS

CEP obor

—

OECD FORD obor

20301 - Mechanical engineering

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2017

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

MM Science Journal

ISSN

1803-1269

e-ISSN

—

Svazek periodika

10

Číslo periodika v rámci svazku

5

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

9

Strana od-do

1995-2003

Kód UT WoS článku

—

EID výsledku v databázi Scopus

2-s2.0-85038078045