Influence of the Drece process of severe plastic deformation on the mechanical properties of the ultra-low carbon interstitial free steel

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F61989100%3A27230%2F18%3A10241160" target="_blank" >RIV/61989100:27230/18:10241160 - isvavai.cz</a>

Výsledek na webu

<a href="http://www.imim.pl/files/archiwum/Vol4_2018/70.pdf" target="_blank" >http://www.imim.pl/files/archiwum/Vol4_2018/70.pdf</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.24425/amm.2018.125148" target="_blank" >10.24425/amm.2018.125148</a>

Jazyk výsledku

angličtina

Název v původním jazyce

Influence of the Drece process of severe plastic deformation on the mechanical properties of the ultra-low carbon interstitial free steel

Popis výsledku v původním jazyce

This research paper shows the influence of a repeated SPD (Severe Plastic Deformation) plastic forming with the DRECE technique (Dual Rolls Equal Channel Extrusion) on hardening of low carbon IF steel. The influence of number of passes through the device on change of mechanical properties, such as tensile strength TS and yield stress YS, of tested steel was tested. The developed method is based on equal channel extrusion with dual rolls and uses a repeated plastic forming to refinement of structure and improve mechanical properties of metal bands [1-2]. For the tested steel the increase of strength properties after the DRECE process was confirmed after the first pass in relation to the initial material. The biggest strain hardening is observed after the fourth pass.

Název v anglickém jazyce

Influence of the Drece process of severe plastic deformation on the mechanical properties of the ultra-low carbon interstitial free steel

Popis výsledku anglicky

This research paper shows the influence of a repeated SPD (Severe Plastic Deformation) plastic forming with the DRECE technique (Dual Rolls Equal Channel Extrusion) on hardening of low carbon IF steel. The influence of number of passes through the device on change of mechanical properties, such as tensile strength TS and yield stress YS, of tested steel was tested. The developed method is based on equal channel extrusion with dual rolls and uses a repeated plastic forming to refinement of structure and improve mechanical properties of metal bands [1-2]. For the tested steel the increase of strength properties after the DRECE process was confirmed after the first pass in relation to the initial material. The biggest strain hardening is observed after the fourth pass.

Druh

J_imp - Článek v periodiku v databázi Web of Science

CEP obor

—

OECD FORD obor

20301 - Mechanical engineering

Projekt

—

Návaznosti

N - Vyzkumna aktivita podporovana z neverejnych zdroju

Rok uplatnění

2018

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Archives of Metallurgy and Materials

ISSN

1733-3490

e-ISSN

—

Svazek periodika

63

Číslo periodika v rámci svazku

4

Stát vydavatele periodika

PL - Polská republika

Počet stran výsledku

6

Strana od-do

2095-2100

Kód UT WoS článku

000453260800070

EID výsledku v databázi Scopus

2-s2.0-85061233178