Investigation of Significant Parameters during Abrasive Waterjet Turning
Identifikátory výsledku
Kód výsledku v IS VaVaI
<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F61989100%3A27240%2F21%3A10248040" target="_blank" >RIV/61989100:27240/21:10248040 - isvavai.cz</a>
Výsledek na webu
<a href="https://www.mdpi.com/1996-1944/14/16/4389" target="_blank" >https://www.mdpi.com/1996-1944/14/16/4389</a>
DOI - Digital Object Identifier
<a href="http://dx.doi.org/10.3390/ma14164389" target="_blank" >10.3390/ma14164389</a>
Alternativní jazyky
Jazyk výsledku
angličtina
Název v původním jazyce
Investigation of Significant Parameters during Abrasive Waterjet Turning
Popis výsledku v původním jazyce
This paper presents an investigation of abrasive waterjet turning (AWJT). The purpose of the article was to investigate significant parameters of the turning process and to evaluate their impact on the turning product. The influence of the traverse speed, the rotational speed, and the relative position of the jet to the specimen (lateral jet shift) were investigated. Based on the previous research done in this field, the multi-pass tangential turning method was selected. Rotational speed does not seem to have a significant impact on the AWJ turning process. However, the relative position of the jet is a key parameter for improving the efficiency of the process. Increasing the lateral jet shift causes the volume of the material removed to increase until the optimal impact angle is reached. These findings need to be extended in order to adjust AWJT. Without these improvements, a comparison of jet to traditional technologies is inappropriate.
Název v anglickém jazyce
Investigation of Significant Parameters during Abrasive Waterjet Turning
Popis výsledku anglicky
This paper presents an investigation of abrasive waterjet turning (AWJT). The purpose of the article was to investigate significant parameters of the turning process and to evaluate their impact on the turning product. The influence of the traverse speed, the rotational speed, and the relative position of the jet to the specimen (lateral jet shift) were investigated. Based on the previous research done in this field, the multi-pass tangential turning method was selected. Rotational speed does not seem to have a significant impact on the AWJ turning process. However, the relative position of the jet is a key parameter for improving the efficiency of the process. Increasing the lateral jet shift causes the volume of the material removed to increase until the optimal impact angle is reached. These findings need to be extended in order to adjust AWJT. Without these improvements, a comparison of jet to traditional technologies is inappropriate.
Klasifikace
Druh
J<sub>imp</sub> - Článek v periodiku v databázi Web of Science
CEP obor
—
OECD FORD obor
20301 - Mechanical engineering
Návaznosti výsledku
Projekt
—
Návaznosti
S - Specificky vyzkum na vysokych skolach
Ostatní
Rok uplatnění
2021
Kód důvěrnosti údajů
S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů
Údaje specifické pro druh výsledku
Název periodika
Materials
ISSN
1996-1944
e-ISSN
—
Svazek periodika
14
Číslo periodika v rámci svazku
16
Stát vydavatele periodika
CH - Švýcarská konfederace
Počet stran výsledku
15
Strana od-do
"4389(1)"-"4389(15)"
Kód UT WoS článku
000689595400001
EID výsledku v databázi Scopus
—