Ultra jemné tvářené zrna během ECAP v Al-Mg-Si slitině

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F61989100%3A27360%2F05%3A00012934" target="_blank" >RIV/61989100:27360/05:00012934 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Ultrafine grain formation during equal channel angular extrusion in an Al-Mg-Si alloy

Popis výsledku v původním jazyce

Microstructural development of aluminium alloy 6082 during equal-channel angular pressing was investigated to understand the mechanisms of grain refinement and strain accommodation. The samples were extruded at room temperature. Cross-section of originalsamples was 8 x 8 mm and their length was 32 mm. Deformation forces were measured during extrusion, resistance to deformation was calculated and deformation speed was determined approximately. Analysis of structure was made with use of light microscopyand SEM. Mechanical properties of samples after extrusion were determined by tensile test and by so called penetration test

Název v anglickém jazyce

Ultrafine grain formation during equal channel angular extrusion in an Al-Mg-Si alloy

Popis výsledku anglicky

Microstructural development of aluminium alloy 6082 during equal-channel angular pressing was investigated to understand the mechanisms of grain refinement and strain accommodation. The samples were extruded at room temperature. Cross-section of originalsamples was 8 x 8 mm and their length was 32 mm. Deformation forces were measured during extrusion, resistance to deformation was calculated and deformation speed was determined approximately. Analysis of structure was made with use of light microscopyand SEM. Mechanical properties of samples after extrusion were determined by tensile test and by so called penetration test

Druh

D - Stať ve sborníku

CEP obor

JG - Hutnictví, kovové materiály

OECD FORD obor

—

Projekt

—

Návaznosti

Z - Vyzkumny zamer (s odkazem do CEZ)

Rok uplatnění

2005

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

11th Scientific Conference CAMS3S 2005

ISBN

83-89728-19-2

ISSN

—

e-ISSN

—

Počet stran výsledku

1

Strana od-do

376-376

Název nakladatele

TU Gliwice

Místo vydání

Gliwice

Místo konání akce

Zakopane, Polsko

Datum konání akce

6. 12. 2005

Typ akce podle státní příslušnosti

EUR - Evropská akce

Kód UT WoS článku

—