Struktura a mechanické vlastnosti vybraných kovů po ECAP
Identifikátory výsledku
Kód výsledku v IS VaVaI
<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F61989100%3A27360%2F06%3A00014290" target="_blank" >RIV/61989100:27360/06:00014290 - isvavai.cz</a>
Výsledek na webu
—
DOI - Digital Object Identifier
—
Alternativní jazyky
Jazyk výsledku
angličtina
Název v původním jazyce
The structure and mechanical properties of chosen metals after ECAP
Popis výsledku v původním jazyce
This paper was aimed at verification of functionally of the ECAP technology at extrusion of the copper and aluminium alloys and steel. Deformation forces were measured during extrusion, resistence to deformation was calculated and deformation speed was approximately determined. Analysis of structure was made by using of light microscopy and FEM. The samples of Cu and Al alloys were extruded at room temperature. For the samples of steel was used the two-stage pressing, when the samples were at temperature of approx. T1=325ºC and T2= 220ºC. In order to increase the concentration of deformation in volume of the samples, the samples were turned around their longitudinal axis by 90º after and they were extruded again.
Název v anglickém jazyce
The structure and mechanical properties of chosen metals after ECAP
Popis výsledku anglicky
This paper was aimed at verification of functionally of the ECAP technology at extrusion of the copper and aluminium alloys and steel. Deformation forces were measured during extrusion, resistence to deformation was calculated and deformation speed was approximately determined. Analysis of structure was made by using of light microscopy and FEM. The samples of Cu and Al alloys were extruded at room temperature. For the samples of steel was used the two-stage pressing, when the samples were at temperature of approx. T1=325ºC and T2= 220ºC. In order to increase the concentration of deformation in volume of the samples, the samples were turned around their longitudinal axis by 90º after and they were extruded again.
Klasifikace
Druh
J<sub>x</sub> - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)
CEP obor
JG - Hutnictví, kovové materiály
OECD FORD obor
—
Návaznosti výsledku
Projekt
—
Návaznosti
Z - Vyzkumny zamer (s odkazem do CEZ)
Ostatní
Rok uplatnění
2006
Kód důvěrnosti údajů
S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů
Údaje specifické pro druh výsledku
Název periodika
Journal of Achievements in Materials and Manufacturing Engineering
ISSN
1734-8412
e-ISSN
—
Svazek periodika
18
Číslo periodika v rámci svazku
1-2
Stát vydavatele periodika
PL - Polská republika
Počet stran výsledku
4
Strana od-do
203-206
Kód UT WoS článku
—
EID výsledku v databázi Scopus
—