Mechanical properties and wear resistance of magnesium casting alloys

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F61989100%3A27360%2F08%3A00019630" target="_blank" >RIV/61989100:27360/08:00019630 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Mechanical properties and wear resistance of magnesium casting alloys

Popis výsledku v původním jazyce

Magnesium alloys are primarily used in aeronautical and automobile industry in wide variety of structural characteristics because of their favourable combination of tensile strength (160 to 365 MPa), elastic modulus (45 GPa), and low density (1 740 kg/m3), which is two-thirds that of aluminium). Magnesium alloys have high strength-to-weight ratio (tensile strength/density), comparable to those of other structural metals. Knowledge of mechanical properties and wear resistance is often important for complex evaluation of magnesium-aluminium alloys. Objective of the work was focused on determination mechanical properties of magnesium-aluminium alloys, including investigation of fracture characteristics with use of SEM analysis and wear resistance test. Mg-Al alloys as cast and after heat treatment were used.

Název v anglickém jazyce

Mechanical properties and wear resistance of magnesium casting alloys

Popis výsledku anglicky

Magnesium alloys are primarily used in aeronautical and automobile industry in wide variety of structural characteristics because of their favourable combination of tensile strength (160 to 365 MPa), elastic modulus (45 GPa), and low density (1 740 kg/m3), which is two-thirds that of aluminium). Magnesium alloys have high strength-to-weight ratio (tensile strength/density), comparable to those of other structural metals. Knowledge of mechanical properties and wear resistance is often important for complex evaluation of magnesium-aluminium alloys. Objective of the work was focused on determination mechanical properties of magnesium-aluminium alloys, including investigation of fracture characteristics with use of SEM analysis and wear resistance test. Mg-Al alloys as cast and after heat treatment were used.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JG - Hutnictví, kovové materiály

OECD FORD obor

—

Projekt

—

Návaznosti

Z - Vyzkumny zamer (s odkazem do CEZ)

Rok uplatnění

2008

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Journal of Achievements in Materials and Manufacturing Engineering

ISSN

1734-8412

e-ISSN

—

Svazek periodika

31

Číslo periodika v rámci svazku

1

Stát vydavatele periodika

PL - Polská republika

Počet stran výsledku

8

Strana od-do

—

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—