Mathematical Simulation in Optimisation of Roll Pass Progression

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F61989100%3A27360%2F11%3A86081447" target="_blank" >RIV/61989100:27360/11:86081447 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Mathematical Simulation in Optimisation of Roll Pass Progression

Popis výsledku v původním jazyce

The results concern roll pass design for rolling a round bar of a 20mm diameter from a 50mm input. Concerning materials, this roll pass design must cover a wide range of steels, from low-carbon micro-alloyed steels to stainless steels. The roll pass design proposal takes into consideration lower plasticity of certain steels. The comparison was enabled by suggesting two roll pass designs. The classical roll pass design oval-round, where the maximum extension coefficient is set to 1.55 in oval and 1.22 inround grooves. The second roll pass design uses a combination of smooth part of the roll (curves) and round roll passes. Distribution of the extension coefficient in individual passes is similar to that of oval-round series. The paper also compares values of energy-force parameters calculated analytically using the method of finite elements. If we compare the distribution of temperature, stress and size of the grain, it is proved that the oval-round roll pass designs are the best as far

Název v anglickém jazyce

Mathematical Simulation in Optimisation of Roll Pass Progression

Popis výsledku anglicky

The results concern roll pass design for rolling a round bar of a 20mm diameter from a 50mm input. Concerning materials, this roll pass design must cover a wide range of steels, from low-carbon micro-alloyed steels to stainless steels. The roll pass design proposal takes into consideration lower plasticity of certain steels. The comparison was enabled by suggesting two roll pass designs. The classical roll pass design oval-round, where the maximum extension coefficient is set to 1.55 in oval and 1.22 inround grooves. The second roll pass design uses a combination of smooth part of the roll (curves) and round roll passes. Distribution of the extension coefficient in individual passes is similar to that of oval-round series. The paper also compares values of energy-force parameters calculated analytically using the method of finite elements. If we compare the distribution of temperature, stress and size of the grain, it is proved that the oval-round roll pass designs are the best as far

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JG - Hutnictví, kovové materiály

OECD FORD obor

—

Projekt

<a href="/cs/project/ED0040%2F01%2F01" target="_blank" >ED0040/01/01: Regionální materiálově technologické výzkumné centrum</a><br>

Návaznosti

P - Projekt vyzkumu a vyvoje financovany z verejnych zdroju (s odkazem do CEP)<br>Z - Vyzkumny zamer (s odkazem do CEZ)

Rok uplatnění

2011

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Hutnické listy

ISSN

0018-8069

e-ISSN

—

Svazek periodika

64

Číslo periodika v rámci svazku

4

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

4

Strana od-do

88-91

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—