Numerical simulation of the heat treatment of the weld for steam generator

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F61989100%3A27360%2F16%3A10252017" target="_blank" >RIV/61989100:27360/16:10252017 - isvavai.cz</a>

Výsledek na webu

<a href="https://www.webofscience.com/wos/woscc/full-record/WOS:000376167100043" target="_blank" >https://www.webofscience.com/wos/woscc/full-record/WOS:000376167100043</a>

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Numerical simulation of the heat treatment of the weld for steam generator

Popis výsledku v původním jazyce

Heat treatment of the weld of the steam generator is investigated in this paper. Annealing is realized by system of heating elements that are placed on casing of the generator. An experiment using real parameters and a computational fluid dynamics analysis using COMSOL Multiphysics software were performed. Experimental data were compared with results of the analysis. Boundary conditions for numerical prediction had been derived on basis of results obtained from a supplementary calibration experiment. There was good correlation between predicted and measured data. Based on results it can be stated that 67 heating elements with heating output of 60-70 % of maximum range is sufficient number for required heat treatment. (C) 2016, Faculty of Metallurgy. All Rights Reserved.

Název v anglickém jazyce

Numerical simulation of the heat treatment of the weld for steam generator

Popis výsledku anglicky

Heat treatment of the weld of the steam generator is investigated in this paper. Annealing is realized by system of heating elements that are placed on casing of the generator. An experiment using real parameters and a computational fluid dynamics analysis using COMSOL Multiphysics software were performed. Experimental data were compared with results of the analysis. Boundary conditions for numerical prediction had been derived on basis of results obtained from a supplementary calibration experiment. There was good correlation between predicted and measured data. Based on results it can be stated that 67 heating elements with heating output of 60-70 % of maximum range is sufficient number for required heat treatment. (C) 2016, Faculty of Metallurgy. All Rights Reserved.

Druh

J_imp - Článek v periodiku v databázi Web of Science

CEP obor

—

OECD FORD obor

20500 - Materials engineering

Projekt

<a href="/cs/project/LO1203" target="_blank" >LO1203: Regionální materiálově technologické výzkumné centrum - Program udržitelnosti</a><br>

Návaznosti

P - Projekt vyzkumu a vyvoje financovany z verejnych zdroju (s odkazem do CEP)<br>S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2016

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Metalurgija

ISSN

0543-5846

e-ISSN

—

Svazek periodika

55

Číslo periodika v rámci svazku

4

Stát vydavatele periodika

HR - Chorvatská republika

Počet stran výsledku

4

Strana od-do

741-744

Kód UT WoS článku

000376167100043

EID výsledku v databázi Scopus

2-s2.0-84966356297