Material Properties Analysis after Heat Treatment

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F62156489%3A43210%2F17%3A43912861" target="_blank" >RIV/62156489:43210/17:43912861 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Material Properties Analysis after Heat Treatment

Popis výsledku v původním jazyce

This article addresses the influence of heat treatment and corrosion degradation on the mechanical properties of material. The introduction contains information related to the issue of the steel heat treatment theory. The aim of this article is to verify the influence of recrystallization annealing, hardening and refining on the mechanical properties of high-quality carbon steel 12 050. After selecting a suitable material for this experiment, tensile plates were made by the water jet from sheet metal for the tensile tests which were made on the university blasting device. The experiment compares the influence of corrosion degradation, in particular heat treatments. Hardness, corrosion and tensile strength tests during which also the values of acoustic emissions were recorded, are verified here. Pen test (Hsu-Nielson) was used for the activation of signal. The results of the measurements are supplemented by graphs from the course of the tensile test as well as by an acoustic emission record.

Název v anglickém jazyce

Material Properties Analysis after Heat Treatment

Popis výsledku anglicky

This article addresses the influence of heat treatment and corrosion degradation on the mechanical properties of material. The introduction contains information related to the issue of the steel heat treatment theory. The aim of this article is to verify the influence of recrystallization annealing, hardening and refining on the mechanical properties of high-quality carbon steel 12 050. After selecting a suitable material for this experiment, tensile plates were made by the water jet from sheet metal for the tensile tests which were made on the university blasting device. The experiment compares the influence of corrosion degradation, in particular heat treatments. Hardness, corrosion and tensile strength tests during which also the values of acoustic emissions were recorded, are verified here. Pen test (Hsu-Nielson) was used for the activation of signal. The results of the measurements are supplemented by graphs from the course of the tensile test as well as by an acoustic emission record.

Druh

J_ost - Ostatní články v recenzovaných periodicích

CEP obor

—

OECD FORD obor

20306 - Audio engineering, reliability analysis

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2017

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Agricultural, Forest and Transport Machinery and Technologies

ISSN

2367-5888

e-ISSN

—

Svazek periodika

4

Číslo periodika v rámci svazku

1

Stát vydavatele periodika

BG - Bulharská republika

Počet stran výsledku

8

Strana od-do

5-12

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—