Energetická náročnost při řezání dřevěných materiálů

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F62156489%3A43410%2F05%3A00084814" target="_blank" >RIV/62156489:43410/05:00084814 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Energy dependenciens with sawing hardboard materials

Popis výsledku v původním jazyce

The objective of the paper is information on the accuracy of methods of the cutting power calculation and their agreement with results obtained by an experiment. Therefore, an experiment was selected of the lengtwise cutting of wood by a circular saw blade. Moment of torsion and the size of feed force are measured quantities while cutting rate is a constant quantity and feed rate and the thickness of a ripped material are variables. For the theoretical calculation, four methods were used. By means of comparisons with measured values it has been experimentally confirmed that the analytical method of calculation approaches most to the reality. The volume method and the tabular force method showed the smallest congruence with the experiment. The experiment also corroborated an increase in cutting power and feed force with feed rate.

Název v anglickém jazyce

Energy dependenciens with sawing hardboard materials

Popis výsledku anglicky

The objective of the paper is information on the accuracy of methods of the cutting power calculation and their agreement with results obtained by an experiment. Therefore, an experiment was selected of the lengtwise cutting of wood by a circular saw blade. Moment of torsion and the size of feed force are measured quantities while cutting rate is a constant quantity and feed rate and the thickness of a ripped material are variables. For the theoretical calculation, four methods were used. By means of comparisons with measured values it has been experimentally confirmed that the analytical method of calculation approaches most to the reality. The volume method and the tabular force method showed the smallest congruence with the experiment. The experiment also corroborated an increase in cutting power and feed force with feed rate.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JR - Ostatní strojírenství

OECD FORD obor

—

Projekt

—

Návaznosti

Z - Vyzkumny zamer (s odkazem do CEZ)

Rok uplatnění

2005

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Roczniki Akademii Rolniczej w Poznaniu, Technol. Drewn.

ISSN

1506-4034

e-ISSN

—

Svazek periodika

CCCLXVIII

Číslo periodika v rámci svazku

40

Stát vydavatele periodika

PL - Polská republika

Počet stran výsledku

7

Strana od-do

193-199

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—