THE IMPORTANCE OF THE CONFIGURATION OF THE WORKING PARAMETERS OF THE WET SHAKER TABLE FOR THE RECOVERY OF METALS FROM MUNICIPAL SOLID WASTE INCINERATION BOTTOM ASH FINE FRACTIO

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F67985858%3A_____%2F23%3A00573251" target="_blank" >RIV/67985858:_____/23:00573251 - isvavai.cz</a>

Výsledek na webu

<a href="https://hdl.handle.net/11104/0343724" target="_blank" >https://hdl.handle.net/11104/0343724</a>

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

THE IMPORTANCE OF THE CONFIGURATION OF THE WORKING PARAMETERS OF THE WET SHAKER TABLE FOR THE RECOVERY OF METALS FROM MUNICIPAL SOLID WASTE INCINERATION BOTTOM ASH FINE FRACTIO

Popis výsledku v původním jazyce

This research focuses on the analysis of the influence of some of the most important working parameters of the wet shaking table on the concentration and recovery of copper and elemental aluminum on the MSWI-BA fine fraction below 0.5 millimeters. For this purpose, a series of 16 tests was carried out with all possible combinations of the minimum and the maximum values of four of the most relevant working parameters of the wet shaker table: shakes amplitude, frequency of shakes, washing water volume, and horizontal tilt. For this research a laboratory semi-industrial wet shaker table were used, and for chemical analysis the concentration of copper was measured by ICP-OES, and the concentration of elemental aluminum was determined by measuring the amount of hydrogen generated in the reaction of elemental aluminum with a solution of sodium hydroxide (NaOH).n

Název v anglickém jazyce

THE IMPORTANCE OF THE CONFIGURATION OF THE WORKING PARAMETERS OF THE WET SHAKER TABLE FOR THE RECOVERY OF METALS FROM MUNICIPAL SOLID WASTE INCINERATION BOTTOM ASH FINE FRACTIO

Popis výsledku anglicky

This research focuses on the analysis of the influence of some of the most important working parameters of the wet shaking table on the concentration and recovery of copper and elemental aluminum on the MSWI-BA fine fraction below 0.5 millimeters. For this purpose, a series of 16 tests was carried out with all possible combinations of the minimum and the maximum values of four of the most relevant working parameters of the wet shaker table: shakes amplitude, frequency of shakes, washing water volume, and horizontal tilt. For this research a laboratory semi-industrial wet shaker table were used, and for chemical analysis the concentration of copper was measured by ICP-OES, and the concentration of elemental aluminum was determined by measuring the amount of hydrogen generated in the reaction of elemental aluminum with a solution of sodium hydroxide (NaOH).n

Druh

O - Ostatní výsledky

CEP obor

—

OECD FORD obor

20402 - Chemical process engineering

Projekt

—

Návaznosti

I - Institucionalni podpora na dlouhodoby koncepcni rozvoj vyzkumne organizace

Rok uplatnění

2023

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů