The measurement of the velocity of abrasive particlesat the suction part of the cutting head

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F68145535%3A_____%2F15%3A00452211" target="_blank" >RIV/68145535:_____/15:00452211 - isvavai.cz</a>

Výsledek na webu

<a href="http://dx.doi.org/10.17559/TV-20140214152925" target="_blank" >http://dx.doi.org/10.17559/TV-20140214152925</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.17559/TV-20140214152925" target="_blank" >10.17559/TV-20140214152925</a>

Jazyk výsledku

angličtina

Název v původním jazyce

The measurement of the velocity of abrasive particlesat the suction part of the cutting head

Popis výsledku v původním jazyce

To be able to optimize the design of the abrasive cutting head using numerical simulation, it is necessary to gather as much information about processes occurring in the cutting head as possible. The development of the numerical model of processes occurring in the abrasive water jet cutting head during the process of creation and forming of abrasive water jet is currently in progress at the Institute of Geonics in Ostrava. The verification of the model requires, among others, to determine the behaviourof abrasive particles at the input of the cutting head. Therefore, the visualisation of abrasive particles at the input using various parameters of abrasive jet and its subsequent analysis was performed using shadowgraphy (backlighting) technique and theresults are presented in the paper.

Název v anglickém jazyce

The measurement of the velocity of abrasive particlesat the suction part of the cutting head

Popis výsledku anglicky

To be able to optimize the design of the abrasive cutting head using numerical simulation, it is necessary to gather as much information about processes occurring in the cutting head as possible. The development of the numerical model of processes occurring in the abrasive water jet cutting head during the process of creation and forming of abrasive water jet is currently in progress at the Institute of Geonics in Ostrava. The verification of the model requires, among others, to determine the behaviourof abrasive particles at the input of the cutting head. Therefore, the visualisation of abrasive particles at the input using various parameters of abrasive jet and its subsequent analysis was performed using shadowgraphy (backlighting) technique and theresults are presented in the paper.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JQ - Strojní zařízení a nástroje

OECD FORD obor

—

Projekt

Výsledek vznikl pri realizaci vícero projektů. Více informací v záložce Projekty.

Návaznosti

I - Institucionalni podpora na dlouhodoby koncepcni rozvoj vyzkumne organizace

Rok uplatnění

2015

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Technicki vjesnik - Technical Gazette

ISSN

1330-3651

e-ISSN

—

Svazek periodika

22

Číslo periodika v rámci svazku

6

Stát vydavatele periodika

HR - Chorvatská republika

Počet stran výsledku

6

Strana od-do

1441-1446

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—