Není k dispozici

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F68407700%3A21220%2F06%3A02125755" target="_blank" >RIV/68407700:21220/06:02125755 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Balancing Analysis of Vertical Axis of Machine Tool LM-2 by Pneumatic System

Popis výsledku v původním jazyce

This paper concerns about a balancing of a certical asis of a machine tool LM-2 by pneumatic systém using 2 pneumatic cylinders. The pneumatic cylinder are connected eith an air-pressure tank. Working pressure inside of the air-pressure tank balances weight of compound slide rest in vertical axis. The connection between the airpressure tank and pneumatic cylinders has certain configuration of pipe components. The main aim was determiming of force unbalance causedby the rapid movement of vertical axis during work cycles. The force unbalance significantly influences behaviour of the servomotors which are needkessly overloaded. This is the main reason for minimizing of this force unbalance caused by pneumatic systém. Both numerical simulation (MATLAB) andexperimental were accomplished. Measurements were carried out on high-dynamic milling centre LM-2 development in Research Centre of Manufacturing Engineering. Obtained results of numerical is in good agreement with measured data.

Název v anglickém jazyce

Balancing Analysis of Vertical Axis of Machine Tool LM-2 by Pneumatic System

Popis výsledku anglicky

This paper concerns about a balancing of a certical asis of a machine tool LM-2 by pneumatic systém using 2 pneumatic cylinders. The pneumatic cylinder are connected eith an air-pressure tank. Working pressure inside of the air-pressure tank balances weight of compound slide rest in vertical axis. The connection between the airpressure tank and pneumatic cylinders has certain configuration of pipe components. The main aim was determiming of force unbalance causedby the rapid movement of vertical axis during work cycles. The force unbalance significantly influences behaviour of the servomotors which are needkessly overloaded. This is the main reason for minimizing of this force unbalance caused by pneumatic systém. Both numerical simulation (MATLAB) andexperimental were accomplished. Measurements were carried out on high-dynamic milling centre LM-2 development in Research Centre of Manufacturing Engineering. Obtained results of numerical is in good agreement with measured data.

Druh

D - Stať ve sborníku

CEP obor

JQ - Strojní zařízení a nástroje

OECD FORD obor

—

Projekt

<a href="/cs/project/1M0507" target="_blank" >1M0507: Výzkum strojírenské výrobní techniky a technologie</a><br>

Návaznosti

P - Projekt vyzkumu a vyvoje financovany z verejnych zdroju (s odkazem do CEP)

Rok uplatnění

2006

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

5th International Conference on Advanced Engineering Design

ISBN

80-86059-44-8

ISSN

—

e-ISSN

—

Počet stran výsledku

8

Strana od-do

1-8

Název nakladatele

ČVUT

Místo vydání

Praha

Místo konání akce

Praha

Datum konání akce

11. 6. 2006

Typ akce podle státní příslušnosti

CST - Celostátní akce

Kód UT WoS článku

—