Není k dispozici

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F68407700%3A21220%2F06%3A02128900" target="_blank" >RIV/68407700:21220/06:02128900 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Surface Roughness og Hardened Steel in Precision Milling with Ceramic and Cubic Boron Nitride Cutting Tool

Popis výsledku v původním jazyce

Precision machining of hardened steels is a topic of high interest to substitute some abrasive operations. Machining of hardened steel differs from conventional machining because of the hardness of the workpiece materials and the cutting tool materials that are required. Hard materials are characterized by high hardness (> 45 HRC) and abrasiveness. The machining process requires the cutting tool of much higher hardness and also higher resistance of the abrasive wear. Advanced tool materials such as cubic boron nitride and ceramics cutting tools are considered to have the ability of cutting such steels. There are some advantages of hard cutting over the abrasive machining e.g. some characteristics of surface integrity. This paper deals with some aspectsand the results of experimental research of the residual stresses in milling of hardened steels.

Název v anglickém jazyce

Surface Roughness og Hardened Steel in Precision Milling with Ceramic and Cubic Boron Nitride Cutting Tool

Popis výsledku anglicky

Precision machining of hardened steels is a topic of high interest to substitute some abrasive operations. Machining of hardened steel differs from conventional machining because of the hardness of the workpiece materials and the cutting tool materials that are required. Hard materials are characterized by high hardness (> 45 HRC) and abrasiveness. The machining process requires the cutting tool of much higher hardness and also higher resistance of the abrasive wear. Advanced tool materials such as cubic boron nitride and ceramics cutting tools are considered to have the ability of cutting such steels. There are some advantages of hard cutting over the abrasive machining e.g. some characteristics of surface integrity. This paper deals with some aspectsand the results of experimental research of the residual stresses in milling of hardened steels.

Druh

C - Kapitola v odborné knize

CEP obor

JR - Ostatní strojírenství

OECD FORD obor

—

Projekt

<a href="/cs/project/GA101%2F06%2F0508" target="_blank" >GA101/06/0508: Výzkum vlastností povrchu a povrchové vrstvy se zřetelem na možné katastrofické dopady na funkčnost strojních součástí</a><br>

Návaznosti

P - Projekt vyzkumu a vyvoje financovany z verejnych zdroju (s odkazem do CEP)

Rok uplatnění

2006

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název knihy nebo sborníku

Science Report - Project PL-007 - Modern Metrology in Quality Management Systems

ISBN

978-83-88906-66-4

Počet stran výsledku

8

Strana od-do

111-118

Počet stran knihy

—

Název nakladatele

Kielce University of Technology

Místo vydání

Kielce

Kód UT WoS kapitoly

—