Experimental Determination of Adhesive Shear Modulus and Verification by FEM

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F68407700%3A21220%2F10%3A00173656" target="_blank" >RIV/68407700:21220/10:00173656 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Experimental Determination of Adhesive Shear Modulus and Verification by FEM

Popis výsledku v původním jazyce

Adhesive joints are increasingly being used due to their mechanical performance and a better understanding of the mechanics of failure. The mechanical properties of bonded joint depend on technology of bonding and mainly on preparation of surfaces of contact areas so it is better to verify data from material sheet with experiment. Real application of the bonded joint is bonding of fixture on the tram roof. Experiment based on standard ČSN EN 14 65 (Determination of Shear Strength in Tension of Rigid Adherends on Lap Joints) was performed and shear modulus of adhesive was calculated. Then program ABAQUS was used to made a model of specimen where the adhesive layer was meshed with cohesive elements. Material properties of cohesive elements were taken from the experiment. In ABAQUS the experiment was also simulated. At the end the values of ultimate strength from experiment were verified with ultimate strength from numerical calculation.

Název v anglickém jazyce

Experimental Determination of Adhesive Shear Modulus and Verification by FEM

Popis výsledku anglicky

Adhesive joints are increasingly being used due to their mechanical performance and a better understanding of the mechanics of failure. The mechanical properties of bonded joint depend on technology of bonding and mainly on preparation of surfaces of contact areas so it is better to verify data from material sheet with experiment. Real application of the bonded joint is bonding of fixture on the tram roof. Experiment based on standard ČSN EN 14 65 (Determination of Shear Strength in Tension of Rigid Adherends on Lap Joints) was performed and shear modulus of adhesive was calculated. Then program ABAQUS was used to made a model of specimen where the adhesive layer was meshed with cohesive elements. Material properties of cohesive elements were taken from the experiment. In ABAQUS the experiment was also simulated. At the end the values of ultimate strength from experiment were verified with ultimate strength from numerical calculation.

Druh

D - Stať ve sborníku

CEP obor

JI - Kompositní materiály

OECD FORD obor

—

Projekt

Výsledek vznikl pri realizaci vícero projektů. Více informací v záložce Projekty.

Návaznosti

P - Projekt vyzkumu a vyvoje financovany z verejnych zdroju (s odkazem do CEP)

Rok uplatnění

2010

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

Computational Mechanics 2010 - Elektronický sborník rozšířených abstraktů

ISBN

978-80-7043-919-7

ISSN

—

e-ISSN

—

Počet stran výsledku

2

Strana od-do

—

Název nakladatele

University of West Bohemia

Místo vydání

Plzeň

Místo konání akce

Hrad Nečtiny

Datum konání akce

8. 11. 2010

Typ akce podle státní příslušnosti

EUR - Evropská akce

Kód UT WoS článku

—