Simulation Testing of the Machine Tool Equipped with the Active Feed Drive

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F68407700%3A21220%2F10%3A00178523" target="_blank" >RIV/68407700:21220/10:00178523 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Simulation Testing of the Machine Tool Equipped with the Active Feed Drive

Popis výsledku v původním jazyce

The vibration of a machine tool is mainly caused by the dynamic acceleration of a motion axis and by the forces that act on it. There are several possibilities how to suppress excited vibration including the recently introduced "motor on motor" techniquewhich is based on the serial connection of two linear motors. This paper presents new simulation results performed on the simulation model of a real machine tool. The maximal achievable tuning of the regulation loop parameters of the motion axis equipped with the "motor on motor" technique was confronted with conventional feed drive. The "motor on motor" feed drive properties were also tested in the virtual machining operation mode where the real measured cutting force was used. Sensitivity analysis ofthe reaction force and middle mass movement of the "motor on motor" feed drive solution to the predicted cutting force introduced to the feed drive control has been researched.

Název v anglickém jazyce

Simulation Testing of the Machine Tool Equipped with the Active Feed Drive

Popis výsledku anglicky

The vibration of a machine tool is mainly caused by the dynamic acceleration of a motion axis and by the forces that act on it. There are several possibilities how to suppress excited vibration including the recently introduced "motor on motor" techniquewhich is based on the serial connection of two linear motors. This paper presents new simulation results performed on the simulation model of a real machine tool. The maximal achievable tuning of the regulation loop parameters of the motion axis equipped with the "motor on motor" technique was confronted with conventional feed drive. The "motor on motor" feed drive properties were also tested in the virtual machining operation mode where the real measured cutting force was used. Sensitivity analysis ofthe reaction force and middle mass movement of the "motor on motor" feed drive solution to the predicted cutting force introduced to the feed drive control has been researched.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JQ - Strojní zařízení a nástroje

OECD FORD obor

—

Projekt

<a href="/cs/project/1M0507" target="_blank" >1M0507: Výzkum strojírenské výrobní techniky a technologie</a><br>

Návaznosti

P - Projekt vyzkumu a vyvoje financovany z verejnych zdroju (s odkazem do CEP)<br>Z - Vyzkumny zamer (s odkazem do CEZ)

Rok uplatnění

2010

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Journal of Machine Engineering

ISSN

1895-7595

e-ISSN

—

Svazek periodika

9

Číslo periodika v rámci svazku

2

Stát vydavatele periodika

PL - Polská republika

Počet stran výsledku

12

Strana od-do

—

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—