Optimization of trimming operations for machining carbon fibre reinforced thermoplastic composite

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F68407700%3A21220%2F13%3A00223347" target="_blank" >RIV/68407700:21220/13:00223347 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Optimization of trimming operations for machining carbon fibre reinforced thermoplastic composite

Popis výsledku v původním jazyce

This paper focuses on machining of thermoplastic composite PPS (polyphenol sulfide) with woven carbon fibers. PPS/C is a commonly used material in the aerospace and aircraft industry for internal panel design and also for structural parts etc. Trimming using milling technology is a possible technology for finishing of the workpiece after prefabrication. In this paper two cutting tools are compared based on the criterion of the final quality of the machined surface edge and cutting forces. The Taguchi method design of experiment (DOE) was used. The main criterion was cutting forces evaluated by S/N ratio. The significance of factors and optimal adjusting of control factors was determined by this method. Secondary criteria were surface roughness and sizeof burr area.

Název v anglickém jazyce

Optimization of trimming operations for machining carbon fibre reinforced thermoplastic composite

Popis výsledku anglicky

This paper focuses on machining of thermoplastic composite PPS (polyphenol sulfide) with woven carbon fibers. PPS/C is a commonly used material in the aerospace and aircraft industry for internal panel design and also for structural parts etc. Trimming using milling technology is a possible technology for finishing of the workpiece after prefabrication. In this paper two cutting tools are compared based on the criterion of the final quality of the machined surface edge and cutting forces. The Taguchi method design of experiment (DOE) was used. The main criterion was cutting forces evaluated by S/N ratio. The significance of factors and optimal adjusting of control factors was determined by this method. Secondary criteria were surface roughness and sizeof burr area.

Druh

D - Stať ve sborníku

CEP obor

JQ - Strojní zařízení a nástroje

OECD FORD obor

—

Projekt

<a href="/cs/project/7E12088" target="_blank" >7E12088: Integrated Process Chain for Automated and Flexible Production of Fibre-Reinforced Plastic Products</a><br>

Návaznosti

P - Projekt vyzkumu a vyvoje financovany z verejnych zdroju (s odkazem do CEP)

Rok uplatnění

2013

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

Proceedings of the International Conference on Advanced Manufacturing Engineering and Technologies

ISBN

978-91-7501-892-8

ISSN

—

e-ISSN

—

Počet stran výsledku

10

Strana od-do

73-82

Název nakladatele

KTH Royal Institute of Technology

Místo vydání

Stockholm

Místo konání akce

Stockholm

Datum konání akce

27. 10. 2013

Typ akce podle státní příslušnosti

WRD - Celosvětová akce

Kód UT WoS článku

—