The Research of the Surface Profile after Profiling of Superalloys

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F68407700%3A21220%2F15%3A00228524" target="_blank" >RIV/68407700:21220/15:00228524 - isvavai.cz</a>

Výsledek na webu

<a href="http://www.sciencedirect.com/science/article/pii/S1877705815004683" target="_blank" >http://www.sciencedirect.com/science/article/pii/S1877705815004683</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.1016/j.proeng.2015.01.441" target="_blank" >10.1016/j.proeng.2015.01.441</a>

Jazyk výsledku

angličtina

Název v původním jazyce

The Research of the Surface Profile after Profiling of Superalloys

Popis výsledku v původním jazyce

Production of so-called superalloys is increasing in the present. This paper is about milling of Inconel 738 LC and Inconel 718. There are main mechanical properties as well as chemical composition of Inconel 738 LC and Inconel 718 in this paper. Special properties of superalloys cause, that they are very hard machining materials, mainly thanks to their high thermal stability during machining. For this reason it was necessary to measure the surface roughness after machining turbine blades made of Inconel 738LC and Inconel 718 depending on profiling. For roughing and finishing of Inconel 738 LC and Inconel 718 were used the best cutting parameters from previous research. After machining of turbine blades were measured parameters of the surface roughness and wear of the cutting tools.

Název v anglickém jazyce

The Research of the Surface Profile after Profiling of Superalloys

Popis výsledku anglicky

Production of so-called superalloys is increasing in the present. This paper is about milling of Inconel 738 LC and Inconel 718. There are main mechanical properties as well as chemical composition of Inconel 738 LC and Inconel 718 in this paper. Special properties of superalloys cause, that they are very hard machining materials, mainly thanks to their high thermal stability during machining. For this reason it was necessary to measure the surface roughness after machining turbine blades made of Inconel 738LC and Inconel 718 depending on profiling. For roughing and finishing of Inconel 738 LC and Inconel 718 were used the best cutting parameters from previous research. After machining of turbine blades were measured parameters of the surface roughness and wear of the cutting tools.

Druh

D - Stať ve sborníku

CEP obor

JQ - Strojní zařízení a nástroje

OECD FORD obor

—

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2015

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

Procedia Engineering

ISBN

—

ISSN

1877-7058

e-ISSN

—

Počet stran výsledku

8

Strana od-do

853-860

Název nakladatele

Elsevier Ltd

Místo vydání

Oxford

Místo konání akce

Vienna

Datum konání akce

25. 11. 2014

Typ akce podle státní příslušnosti

WRD - Celosvětová akce

Kód UT WoS článku

—