Isotropy Verification of the C/PPS Samples Manufactured from Pellets by Image Processing Methods and Experiment

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F68407700%3A21220%2F15%3A00236009" target="_blank" >RIV/68407700:21220/15:00236009 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Isotropy Verification of the C/PPS Samples Manufactured from Pellets by Image Processing Methods and Experiment

Popis výsledku v původním jazyce

The main goal of this work is to determine isotropy (anisotropy) of the samples which were manufactured from C/PPS pellets with random orientation. Image processing analysis of the samples was done to detect the orientation of the pellets on the surface area. Image processing analysis of the samples was done to detect the orientation of the pellets on the surface area. Then mechanical characteristics of the samples were analytically calculated with the modification of classic lamination theory for randomly reinforced composites. FE simulation of the tensile test was done in software ABAQUS with material characteristics obtained by the analytical calculation. Verifying tensile tests based on ASTM D3039 were done on specimens cut from flat plates in both longitudinal a transversal direction.

Název v anglickém jazyce

Isotropy Verification of the C/PPS Samples Manufactured from Pellets by Image Processing Methods and Experiment

Popis výsledku anglicky

The main goal of this work is to determine isotropy (anisotropy) of the samples which were manufactured from C/PPS pellets with random orientation. Image processing analysis of the samples was done to detect the orientation of the pellets on the surface area. Image processing analysis of the samples was done to detect the orientation of the pellets on the surface area. Then mechanical characteristics of the samples were analytically calculated with the modification of classic lamination theory for randomly reinforced composites. FE simulation of the tensile test was done in software ABAQUS with material characteristics obtained by the analytical calculation. Verifying tensile tests based on ASTM D3039 were done on specimens cut from flat plates in both longitudinal a transversal direction.

Druh

O - Ostatní výsledky

CEP obor

JI - Kompositní materiály

OECD FORD obor

—

Projekt

<a href="/cs/project/TA03010209" target="_blank" >TA03010209: Výzkum a vývoj moderních technologií výroby dílů a nových aplikací z high performance kompozitů s termoplastovou matricí</a><br>

Návaznosti

P - Projekt vyzkumu a vyvoje financovany z verejnych zdroju (s odkazem do CEP)

Rok uplatnění

2015

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů