Influence of cutting parameters and plasma cutting mode on cutting quality and process noise

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F68407700%3A21220%2F20%3A00344506" target="_blank" >RIV/68407700:21220/20:00344506 - isvavai.cz</a>

Výsledek na webu

<a href="https://doi.org/10.21062/mft.2020.102" target="_blank" >https://doi.org/10.21062/mft.2020.102</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.21062/mft.2020.102" target="_blank" >10.21062/mft.2020.102</a>

Jazyk výsledku

angličtina

Název v původním jazyce

Influence of cutting parameters and plasma cutting mode on cutting quality and process noise

Popis výsledku v původním jazyce

Plasma cutting is an ever-evolving method of industrial cutting of materials. Like all modern methods, it must meet the requirements for the quality of the cut, but also the hygiene and safety regulations set by European legislation. New ways are being sought to reduce process noise while improving the quality of the cutting surface. The article aims to compare two cutting modes (Contour Cut and Silent Cut) in terms of both the quality of the cut (roughness of the cutting surface, size of the heat affected area, perpendicularity and bevel angle of the cutting surface) and in terms of noise of the cutting pro-cess. The results in the article clearly show that the use of the Silent Cut mode has a demonstrably positive effect on the level of noise produced but also on the quality of the cut.

Název v anglickém jazyce

Influence of cutting parameters and plasma cutting mode on cutting quality and process noise

Popis výsledku anglicky

Plasma cutting is an ever-evolving method of industrial cutting of materials. Like all modern methods, it must meet the requirements for the quality of the cut, but also the hygiene and safety regulations set by European legislation. New ways are being sought to reduce process noise while improving the quality of the cutting surface. The article aims to compare two cutting modes (Contour Cut and Silent Cut) in terms of both the quality of the cut (roughness of the cutting surface, size of the heat affected area, perpendicularity and bevel angle of the cutting surface) and in terms of noise of the cutting pro-cess. The results in the article clearly show that the use of the Silent Cut mode has a demonstrably positive effect on the level of noise produced but also on the quality of the cut.

Druh

J_ost - Ostatní články v recenzovaných periodicích

CEP obor

—

OECD FORD obor

20301 - Mechanical engineering

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2020

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufacturing Technology: Journal for Science, Research and Production

ISSN

1213-2489

e-ISSN

—

Svazek periodika

20

Číslo periodika v rámci svazku

6

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

8

Strana od-do

771-778

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—