Modul koprocesoru pro měření parametrů signálů, založený na procesoru ARM7TDMI

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F68407700%3A21230%2F05%3A03108963" target="_blank" >RIV/68407700:21230/05:03108963 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Coprocessor Module for Measurement of Signals' Parameters Based on ARM7TDMI Processor

Popis výsledku v původním jazyce

In industrial control systems it is necessary to measure parameters of input signals; most important parameters of harmonic signals are the RMS value and power. Sampling requirements for various control systems are similar. To avoid repeated design it ispossible to make a dedicated module denoted as a "measuring coprocessor" as a piggyback module. This module can carry out these measurements and provide results to a superior system. Microprocessors used in such a coprocessor can be based on the ARM architecture, suitable due to its speed, performance and the instruction set. ARM based microprocessors are equipped with large code and data memory on the chip, as well as analog to digital or digital to analog converters. This concept leads to a small simple device, using a single chip and thus very cheap.

Název v anglickém jazyce

Coprocessor Module for Measurement of Signals' Parameters Based on ARM7TDMI Processor

Popis výsledku anglicky

In industrial control systems it is necessary to measure parameters of input signals; most important parameters of harmonic signals are the RMS value and power. Sampling requirements for various control systems are similar. To avoid repeated design it ispossible to make a dedicated module denoted as a "measuring coprocessor" as a piggyback module. This module can carry out these measurements and provide results to a superior system. Microprocessors used in such a coprocessor can be based on the ARM architecture, suitable due to its speed, performance and the instruction set. ARM based microprocessors are equipped with large code and data memory on the chip, as well as analog to digital or digital to analog converters. This concept leads to a small simple device, using a single chip and thus very cheap.

Druh

A - Audiovizuální tvorba

CEP obor

JA - Elektronika a optoelektronika, elektrotechnika

OECD FORD obor

—

Projekt

—

Návaznosti

Z - Vyzkumny zamer (s odkazem do CEZ)

Rok uplatnění

2005

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

ISBN

—

Místo vydání

Praha

Název nakladatele resp. objednatele

—

Verze

—

Identifikační číslo nosiče

neuvedeno