Cable Correction Model for HF Resistance Standards Comparisons

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F68407700%3A21230%2F25%3A00389568" target="_blank" >RIV/68407700:21230/25:00389568 - isvavai.cz</a>

Výsledek na webu

<a href="https://doi.org/10.1109/TIM.2025.3553977" target="_blank" >https://doi.org/10.1109/TIM.2025.3553977</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.1109/TIM.2025.3553977" target="_blank" >10.1109/TIM.2025.3553977</a>

Jazyk výsledku

angličtina

Název v původním jazyce

Cable Correction Model for HF Resistance Standards Comparisons

Popis výsledku v původním jazyce

In this article, we present a model that allows for significantly improving the impedance accuracy of calculable resistance standards. The proposed model extends the correction factor applied to the calculated four-terminal-pair impedance from the connector parts of the standard to the complete measurement circuit concerned by the applied voltage and current, respectively. In particular, we consider the cables and connectors contribution of the impedance bridge electronics. The model has been validated by performing: 1:1 and 0.1:1 impedance comparisons by means of two different typologies of calculable resistance standards. For the measurements, we relied on the accuracy of a digital bridge, which exploits the signals of two Josephson arbitrary waveform synthesizers (JAWSs). The frequency dependence of these new resistors has been analyzed over a range between 1 and 80 kHz.

Název v anglickém jazyce

Cable Correction Model for HF Resistance Standards Comparisons

Popis výsledku anglicky

In this article, we present a model that allows for significantly improving the impedance accuracy of calculable resistance standards. The proposed model extends the correction factor applied to the calculated four-terminal-pair impedance from the connector parts of the standard to the complete measurement circuit concerned by the applied voltage and current, respectively. In particular, we consider the cables and connectors contribution of the impedance bridge electronics. The model has been validated by performing: 1:1 and 0.1:1 impedance comparisons by means of two different typologies of calculable resistance standards. For the measurements, we relied on the accuracy of a digital bridge, which exploits the signals of two Josephson arbitrary waveform synthesizers (JAWSs). The frequency dependence of these new resistors has been analyzed over a range between 1 and 80 kHz.

Druh

J_imp - Článek v periodiku v databázi Web of Science

CEP obor

—

OECD FORD obor

20201 - Electrical and electronic engineering

Projekt

—

Návaznosti

N - Vyzkumna aktivita podporovana z neverejnych zdroju

Rok uplatnění

2025

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

IEEE Transactions on Instrumentation and Measurement

ISSN

0018-9456

e-ISSN

1557-9662

Svazek periodika

74

Číslo periodika v rámci svazku

1503507

Stát vydavatele periodika

US - Spojené státy americké

Počet stran výsledku

7

Strana od-do

1-7

Kód UT WoS článku

001459634000023

EID výsledku v databázi Scopus

2-s2.0-105002291002