Airplane terminal servicing - influence of aircraft stand width on turnaround time

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F68407700%3A21260%2F18%3A00327502" target="_blank" >RIV/68407700:21260/18:00327502 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Airplane terminal servicing - influence of aircraft stand width on turnaround time

Popis výsledku v původním jazyce

This article discusses the influence of an aircraft stand width on turnaround time of a typical short-to-mid haul airplane. The first part of the paper describes a typical arrangement of ground vehicles during the process of airplane terminal servicing. This is followed by an identification of possible difficulties that can occur when those services are performed on the aircraft with maximal wingspan for its class, parked on the NOSE-IN stand designed precisely to the minimum requirements of the regulation that is not equipped with a hydrant system. The second part compares turnaround times for the same aircraft type being serviced with or without those collisions that has been identified. The comparison is done both for a base station and an en-route station, where some ground vehicles are not involved. The final part of the paper is dedicated to the discussion of the influence of the aircraft stand width on the minimal turnaround time

Název v anglickém jazyce

Airplane terminal servicing - influence of aircraft stand width on turnaround time

Popis výsledku anglicky

This article discusses the influence of an aircraft stand width on turnaround time of a typical short-to-mid haul airplane. The first part of the paper describes a typical arrangement of ground vehicles during the process of airplane terminal servicing. This is followed by an identification of possible difficulties that can occur when those services are performed on the aircraft with maximal wingspan for its class, parked on the NOSE-IN stand designed precisely to the minimum requirements of the regulation that is not equipped with a hydrant system. The second part compares turnaround times for the same aircraft type being serviced with or without those collisions that has been identified. The comparison is done both for a base station and an en-route station, where some ground vehicles are not involved. The final part of the paper is dedicated to the discussion of the influence of the aircraft stand width on the minimal turnaround time

Druh

D - Stať ve sborníku

CEP obor

—

OECD FORD obor

20104 - Transport engineering

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2018

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

BulTrans-2018 Proceedings

ISBN

—

ISSN

1313-955X

e-ISSN

—

Počet stran výsledku

4

Strana od-do

43-46

Název nakladatele

Technical University Academic Publishing House

Místo vydání

Sofia

Místo konání akce

Sozopol

Datum konání akce

15. 9. 2018

Typ akce podle státní příslušnosti

WRD - Celosvětová akce

Kód UT WoS článku

—