Tests of UHPC Thin Plates Reinforced by 2D Textile Glass Reinforcement and PVA Fibres

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F68407700%3A21610%2F14%3A00223562" target="_blank" >RIV/68407700:21610/14:00223562 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Tests of UHPC Thin Plates Reinforced by 2D Textile Glass Reinforcement and PVA Fibres

Popis výsledku v původním jazyce

The paper is focused on the research of thin plates made from white ultra-high-performance concrete reinforced by 2D textile glass reinforcement and PVA fibers. These boards should be used as facade or roof panels. This paper presents a computer and experimental analysis of loading of thin UHPC plates. Three specimens owith size of 750 x 125 x 15 mm were made. The specimens were subsequently tested at four-point bending tests in the laboratory. The paper presents a process and results of the experiments. The paper demonstrates correspondence of the experimental and the computer simulated load test results. All specimens were made from UHPC matrix with dissipated PVA fibers 20 mm long and 2D textile glass rein-forcement with 20 x 20 mm net. This reinforcement was located near the lower surface of the board. Instead of a tradi-tional reinforcement the 2D textile glass reinforcement that is equipped with the protection against alkali environment was used. The arrangement corresponds to th

Název v anglickém jazyce

Tests of UHPC Thin Plates Reinforced by 2D Textile Glass Reinforcement and PVA Fibres

Popis výsledku anglicky

The paper is focused on the research of thin plates made from white ultra-high-performance concrete reinforced by 2D textile glass reinforcement and PVA fibers. These boards should be used as facade or roof panels. This paper presents a computer and experimental analysis of loading of thin UHPC plates. Three specimens owith size of 750 x 125 x 15 mm were made. The specimens were subsequently tested at four-point bending tests in the laboratory. The paper presents a process and results of the experiments. The paper demonstrates correspondence of the experimental and the computer simulated load test results. All specimens were made from UHPC matrix with dissipated PVA fibers 20 mm long and 2D textile glass rein-forcement with 20 x 20 mm net. This reinforcement was located near the lower surface of the board. Instead of a tradi-tional reinforcement the 2D textile glass reinforcement that is equipped with the protection against alkali environment was used. The arrangement corresponds to th

Druh

D - Stať ve sborníku

CEP obor

JM - Inženýrské stavitelství

OECD FORD obor

—

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2014

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

EXPERIMENTÁLNÍ A VÝPOČTOVÉ METODY V INŽENÝRSTVÍ

ISBN

978-80-7414-724-1

ISSN

—

e-ISSN

—

Počet stran výsledku

1

Strana od-do

11

Název nakladatele

UJEP

Místo vydání

Ústí nad Labem

Místo konání akce

Ústí nad Labem

Datum konání akce

11. 6. 2014

Typ akce podle státní příslušnosti

EUR - Evropská akce

Kód UT WoS článku

—