LASEROVÁ OBROBITELNOST A KVALITA POVRCHU PŘI OBRÁBĚNÍ PLASTŮ

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F70883521%3A28110%2F05%3A63503960" target="_blank" >RIV/70883521:28110/05:63503960 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

LASER WORKABILITY AND SURFACE QUALITY CHARACTERISTIC OF PLASTICS

Popis výsledku v původním jazyce

In this studies are presented laser workability and results using CO2 laser set-up on the polymer material, which was originally designed to mark object with logos, signatures or bar codes. Although laser micro fabrication is well known, it is only excimer and UV laser that have been used so far to produce microstructures systems in plastic in very good quality. The use of CO2 laser systems instead of the UV lasers and excimer lasers could provide a cost-effective alternative. A good example is production of micro fluidic systems in PMMA substrate (micro fluidic systems are used for various kinds of bio-chemical analyses, such a waste water monitoring, and for medical application). And also the laser machining is very good and chip alternative of the replication method include hot embossing and injection moulding

Název v anglickém jazyce

LASER WORKABILITY AND SURFACE QUALITY CHARACTERISTIC OF PLASTICS

Popis výsledku anglicky

In this studies are presented laser workability and results using CO2 laser set-up on the polymer material, which was originally designed to mark object with logos, signatures or bar codes. Although laser micro fabrication is well known, it is only excimer and UV laser that have been used so far to produce microstructures systems in plastic in very good quality. The use of CO2 laser systems instead of the UV lasers and excimer lasers could provide a cost-effective alternative. A good example is production of micro fluidic systems in PMMA substrate (micro fluidic systems are used for various kinds of bio-chemical analyses, such a waste water monitoring, and for medical application). And also the laser machining is very good and chip alternative of the replication method include hot embossing and injection moulding

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JR - Ostatní strojírenství

OECD FORD obor

—

Projekt

—

Návaznosti

Z - Vyzkumny zamer (s odkazem do CEZ)

Rok uplatnění

2005

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufacturing Technology

ISSN

1213248-9

e-ISSN

—

Svazek periodika

—

Číslo periodika v rámci svazku

5

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

5

Strana od-do

8-12

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—