Vyhodnocení závislosti hloubky drážky na technologických parametrech CO 2 laseru

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F70883521%3A28110%2F06%3A63504499" target="_blank" >RIV/70883521:28110/06:63504499 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

CUTTING DEPTH DETERMINATION WITHIN CO2 LASER MICROMACHINING

Popis výsledku v původním jazyce

The results of CO2 laser micro-machining research are presented in this paper. There was researched laser beam and its using on different types of polymeric materials in details. From experiment it is evident the slot depth grows linear with increasing values of power at concrete adjusted value of feed. Biggest depth is at low values of feed. This phenomenon was observed at all materials. Gradient of lines and correlation coefficients offer information about dependence character of slot depth on adjusted power and feed at graphic presenting results. Value of gradient (k) is used for exact control of stock removal (slot depth). Gradient of line gives information about sloth depth at increasing of power about definite number of percents. Correlation coefficient gives approximate quality of linear dependence (compare with R2 = 1).Resulting structures can be very exact and with high quality of surface in dependence on laser parameters and on type of machining materials

Název v anglickém jazyce

CUTTING DEPTH DETERMINATION WITHIN CO2 LASER MICROMACHINING

Popis výsledku anglicky

The results of CO2 laser micro-machining research are presented in this paper. There was researched laser beam and its using on different types of polymeric materials in details. From experiment it is evident the slot depth grows linear with increasing values of power at concrete adjusted value of feed. Biggest depth is at low values of feed. This phenomenon was observed at all materials. Gradient of lines and correlation coefficients offer information about dependence character of slot depth on adjusted power and feed at graphic presenting results. Value of gradient (k) is used for exact control of stock removal (slot depth). Gradient of line gives information about sloth depth at increasing of power about definite number of percents. Correlation coefficient gives approximate quality of linear dependence (compare with R2 = 1).Resulting structures can be very exact and with high quality of surface in dependence on laser parameters and on type of machining materials

Druh

D - Stať ve sborníku

CEP obor

JJ - Ostatní materiály

OECD FORD obor

—

Projekt

—

Návaznosti

Z - Vyzkumny zamer (s odkazem do CEZ)

Rok uplatnění

2006

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

DAAAM Symposium

ISBN

3-901509-57-7

ISSN

—

e-ISSN

—

Počet stran výsledku

2

Strana od-do

405-406

Název nakladatele

Vienna University of Technology

Místo vydání

Vienna

Místo konání akce

—

Datum konání akce

—

Typ akce podle státní příslušnosti

—

Kód UT WoS článku

—