Vliv řezné rychlosti na kvalitu povrchu při obrábění vodním paprskem

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F70883521%3A28110%2F08%3A63507301" target="_blank" >RIV/70883521:28110/08:63507301 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Impact of the Cutting Speed on the Surface Quality by Waterjet Cutting

Popis výsledku v původním jazyce

This publication is a part of technology of production that uses known physical and chemical effects for material reduction. The above mentioned technology is called unconventional or progressive. Abrasive Water Jet Machining (AWJ) is widely used for machining of all engineering materials, metallic and non-metallic included. Surface topography when AWJ machining has not been deeply explored yet. As well as in case of other highly-energetic jet technologies, there was left visible channelling on the machined surface when AWJ had been used. This channelling substantially affects dimensional accuracy and quality of the finished surface. The aim of this paper was to prove impact of one technological parameter ? cutting speed ? on final surface roughness. Experiments were made in cooperation with Sazovice, s.r.o. company (Limited Liability Company). Slopes of the straight lines and correlation coefficients of graphic results show character of these dependencies. Finally, results of surface

Název v anglickém jazyce

Impact of the Cutting Speed on the Surface Quality by Waterjet Cutting

Popis výsledku anglicky

This publication is a part of technology of production that uses known physical and chemical effects for material reduction. The above mentioned technology is called unconventional or progressive. Abrasive Water Jet Machining (AWJ) is widely used for machining of all engineering materials, metallic and non-metallic included. Surface topography when AWJ machining has not been deeply explored yet. As well as in case of other highly-energetic jet technologies, there was left visible channelling on the machined surface when AWJ had been used. This channelling substantially affects dimensional accuracy and quality of the finished surface. The aim of this paper was to prove impact of one technological parameter ? cutting speed ? on final surface roughness. Experiments were made in cooperation with Sazovice, s.r.o. company (Limited Liability Company). Slopes of the straight lines and correlation coefficients of graphic results show character of these dependencies. Finally, results of surface

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JJ - Ostatní materiály

OECD FORD obor

—

Projekt

—

Návaznosti

Z - Vyzkumny zamer (s odkazem do CEZ)

Rok uplatnění

2008

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Acta Mechanica Slovaca

ISSN

1335-2393

e-ISSN

—

Svazek periodika

12

Číslo periodika v rámci svazku

4A

Stát vydavatele periodika

SK - Slovenská republika

Počet stran výsledku

6

Strana od-do

—

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—