Stress Analysis of Injection ? moulded Cylindrical Parts Reinforced with Short Fibres

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F70883521%3A28110%2F12%3A43868762" target="_blank" >RIV/70883521:28110/12:43868762 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Stress Analysis of Injection ? moulded Cylindrical Parts Reinforced with Short Fibres

Popis výsledku v původním jazyce

An investigation was carried out through a study of the influence of material anisotropy and geometrical parameters of the cylindrical plastic parts reinforced by short-fibres, on the state of stress. It has been shown that the result of such injection-moulded processes is an anisotropic product, whose mechanical behaviour differs considerably for that of classical types of isotropic solids. Unlike unreinforced plastics, fibre composites exhibit different stress phenomena and mechanical properties notably in cases where composite parts are highly curved. These unusual effects of their mechanical properties thus need to be careful consideration in the course of designing of reinforced plastic parts.

Název v anglickém jazyce

Stress Analysis of Injection ? moulded Cylindrical Parts Reinforced with Short Fibres

Popis výsledku anglicky

An investigation was carried out through a study of the influence of material anisotropy and geometrical parameters of the cylindrical plastic parts reinforced by short-fibres, on the state of stress. It has been shown that the result of such injection-moulded processes is an anisotropic product, whose mechanical behaviour differs considerably for that of classical types of isotropic solids. Unlike unreinforced plastics, fibre composites exhibit different stress phenomena and mechanical properties notably in cases where composite parts are highly curved. These unusual effects of their mechanical properties thus need to be careful consideration in the course of designing of reinforced plastic parts.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JJ - Ostatní materiály

OECD FORD obor

—

Projekt

—

Návaznosti

V - Vyzkumna aktivita podporovana z jinych verejnych zdroju

Rok uplatnění

2012

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufacturing Technology

ISSN

1213-2489

e-ISSN

—

Svazek periodika

12

Číslo periodika v rámci svazku

13

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

4

Strana od-do

251-254

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—