Stabilization/solidification of hot dip galvanizing ash using different binders

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F70883521%3A28110%2F16%3A43874642" target="_blank" >RIV/70883521:28110/16:43874642 - isvavai.cz</a>

Výsledek na webu

<a href="http://www.sciencedirect.com/science/article/pii/S0304389416307440" target="_blank" >http://www.sciencedirect.com/science/article/pii/S0304389416307440</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.1016/j.jhazmat.2016.08.023" target="_blank" >10.1016/j.jhazmat.2016.08.023</a>

Jazyk výsledku

angličtina

Název v původním jazyce

Stabilization/solidification of hot dip galvanizing ash using different binders

Popis výsledku v původním jazyce

This study focuses on solidification of hot dip-galvanizing ash with a high content of zinc and soluble substances. The main purpose of this paper is to immobilize these pollutants into a matrix and allow a safer way for landfill disposal of that waste. Three different binders (Portland cement, fly ash and coal fluidized-bed combustion ash) were used for the waste solidification. Effectiveness of the process was evaluated using leaching test according to EN 12457-4 and by using the variance analysis and the categorical multifactorial test. In the leaching test, four parameters were observed: pH, zinc concentration in leachate, and concentration of chlorides and dissolved substances in leachate. The acquired data was then processed using statistical software to find an optimal solidifying ratio of the addition of binder, water, and waste to the mixture, with the aim to fulfil the requirement for landfill disposal set by the Council Decision 2003/33/EC. The influence on the main observed parameters (relative amount of water and a binder) on the effectiveness of the used method and their influence of measured parameters was also studied.

Název v anglickém jazyce

Stabilization/solidification of hot dip galvanizing ash using different binders

Popis výsledku anglicky

This study focuses on solidification of hot dip-galvanizing ash with a high content of zinc and soluble substances. The main purpose of this paper is to immobilize these pollutants into a matrix and allow a safer way for landfill disposal of that waste. Three different binders (Portland cement, fly ash and coal fluidized-bed combustion ash) were used for the waste solidification. Effectiveness of the process was evaluated using leaching test according to EN 12457-4 and by using the variance analysis and the categorical multifactorial test. In the leaching test, four parameters were observed: pH, zinc concentration in leachate, and concentration of chlorides and dissolved substances in leachate. The acquired data was then processed using statistical software to find an optimal solidifying ratio of the addition of binder, water, and waste to the mixture, with the aim to fulfil the requirement for landfill disposal set by the Council Decision 2003/33/EC. The influence on the main observed parameters (relative amount of water and a binder) on the effectiveness of the used method and their influence of measured parameters was also studied.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

DM - Tuhý odpad a jeho kontrola, recyklace

OECD FORD obor

—

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2016

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Journal of Hazardous Materials

ISSN

0304-3894

e-ISSN

—

Svazek periodika

320

Číslo periodika v rámci svazku

Neuveden

Stát vydavatele periodika

NL - Nizozemsko

Počet stran výsledku

9

Strana od-do

105-113

Kód UT WoS článku

—

EID výsledku v databázi Scopus

2-s2.0-84981516082