Improvements of prosthetic limb design: Cooling and pressure reduction in a socket

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F70883521%3A28110%2F17%3A63517047" target="_blank" >RIV/70883521:28110/17:63517047 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Improvements of prosthetic limb design: Cooling and pressure reduction in a socket

Popis výsledku v původním jazyce

Although important improvements of prosthetic sockets has been implemented another investigation has been done also by solving problems with inadequate stump heating and from that resulting excessive sweating of limb. This phenomenon is further associated with leg volume changes. Therefore for realization of this research the model of prosthetic limb was created with socket that further addresses these issues of artificial limb. Throw the application of holes and tightening bells the pressure to remaining stump decreased and at the same time the heating of limb is lower. These results indicate that the implementation of these design modification will improve the comfort and fit of prosthetic devices in future.

Název v anglickém jazyce

Improvements of prosthetic limb design: Cooling and pressure reduction in a socket

Popis výsledku anglicky

Although important improvements of prosthetic sockets has been implemented another investigation has been done also by solving problems with inadequate stump heating and from that resulting excessive sweating of limb. This phenomenon is further associated with leg volume changes. Therefore for realization of this research the model of prosthetic limb was created with socket that further addresses these issues of artificial limb. Throw the application of holes and tightening bells the pressure to remaining stump decreased and at the same time the heating of limb is lower. These results indicate that the implementation of these design modification will improve the comfort and fit of prosthetic devices in future.

Druh

J_SC - Článek v periodiku v databázi SCOPUS

CEP obor

—

OECD FORD obor

20505 - Composites (including laminates, reinforced plastics, cermets, combined natural and synthetic fibre fabrics; filled composites)

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2017

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufacturing Technology

ISSN

1213-2489

e-ISSN

—

Svazek periodika

17

Číslo periodika v rámci svazku

6

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

4

Strana od-do

978-981

Kód UT WoS článku

—

EID výsledku v databázi Scopus

2-s2.0-85038212061