PLA/Clay Nanocomposites for Packaging Application

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F70883521%3A28110%2F19%3A63523332" target="_blank" >RIV/70883521:28110/19:63523332 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

PLA/Clay Nanocomposites for Packaging Application

Popis výsledku v původním jazyce

In the present work, the influence of clay fillers on the PLA matrix was studied, especially from the viewpoint of the gas transport properties and the material morphology. As polymer matrix was use Polylactic acid PLA2003D. The nanofillers in the study were Nanofil 116, Cloisite SE 3010 and Garamite in loading 5%. For PLA/clay mixture preparation a corotating twin screw extruder ZSK 25 (Coperion GmbH, Stuttgart, Germany), temperature range 160°C-200°C was used. In the next step the PLA/clay films were prepared using single-screw extruder type PlastiCorder (Brabender, Germany) with a flat extrusion die (width: 250 mm) at a processing temperature 160°C-200°C, providing thin films of about 0,3 mm thickness. Due to the high potential of using PLA films in the food and packaging industry, the essential characteristic of the material is the permeation of gases and vapors.

Název v anglickém jazyce

PLA/Clay Nanocomposites for Packaging Application

Popis výsledku anglicky

In the present work, the influence of clay fillers on the PLA matrix was studied, especially from the viewpoint of the gas transport properties and the material morphology. As polymer matrix was use Polylactic acid PLA2003D. The nanofillers in the study were Nanofil 116, Cloisite SE 3010 and Garamite in loading 5%. For PLA/clay mixture preparation a corotating twin screw extruder ZSK 25 (Coperion GmbH, Stuttgart, Germany), temperature range 160°C-200°C was used. In the next step the PLA/clay films were prepared using single-screw extruder type PlastiCorder (Brabender, Germany) with a flat extrusion die (width: 250 mm) at a processing temperature 160°C-200°C, providing thin films of about 0,3 mm thickness. Due to the high potential of using PLA films in the food and packaging industry, the essential characteristic of the material is the permeation of gases and vapors.

Druh

O - Ostatní výsledky

CEP obor

—

OECD FORD obor

10404 - Polymer science

Projekt

—

Návaznosti

V - Vyzkumna aktivita podporovana z jinych verejnych zdroju

Rok uplatnění

2019

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů