The Effect of Laser Beam on the Width of the Cut

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F70883521%3A28110%2F24%3A63570860" target="_blank" >RIV/70883521:28110/24:63570860 - isvavai.cz</a>

Výsledek na webu

<a href="http://dx.doi.org/10.1088/1742-6596/2712/1/012019" target="_blank" >http://dx.doi.org/10.1088/1742-6596/2712/1/012019</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.1088/1742-6596/2712/1/012019" target="_blank" >10.1088/1742-6596/2712/1/012019</a>

Jazyk výsledku

angličtina

Název v původním jazyce

The Effect of Laser Beam on the Width of the Cut

Popis výsledku v původním jazyce

Conventional methods of dividing material due to their limitation to straight cuts have largely been replaced by non-conventional cutting methods, which include laser cutting. Laser cutting of polymer materials has become a priority for the manufacturing industry, mainly due to the constantly growing demand for these materials. The article discusses the effect of the laser beam on the width of the cut using lenses with different focal lengths, under different working conditions, on samples made of PMMA polymer material plates. For the experiment, the samples were produced using an ILS 3NM laser device, a CO2, with a wavelength of 10.6 μm and with maximum power 100 W, maximum feed speed 1524 mm·s−1. For the selected samples, it was studied how the dimension defined by the machining software differ from the dimension created by the machining.

Název v anglickém jazyce

The Effect of Laser Beam on the Width of the Cut

Popis výsledku anglicky

Conventional methods of dividing material due to their limitation to straight cuts have largely been replaced by non-conventional cutting methods, which include laser cutting. Laser cutting of polymer materials has become a priority for the manufacturing industry, mainly due to the constantly growing demand for these materials. The article discusses the effect of the laser beam on the width of the cut using lenses with different focal lengths, under different working conditions, on samples made of PMMA polymer material plates. For the experiment, the samples were produced using an ILS 3NM laser device, a CO2, with a wavelength of 10.6 μm and with maximum power 100 W, maximum feed speed 1524 mm·s−1. For the selected samples, it was studied how the dimension defined by the machining software differ from the dimension created by the machining.

Druh

D - Stať ve sborníku

CEP obor

—

OECD FORD obor

20501 - Materials engineering

Projekt

—

Návaznosti

V - Vyzkumna aktivita podporovana z jinych verejnych zdroju

Rok uplatnění

2024

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

Journal of Physics: Conference Series (online)

ISBN

—

ISSN

1742-6596

e-ISSN

—

Počet stran výsledku

11

Strana od-do

1-11

Název nakladatele

Institute of Physics Publishing Ltd.

Místo vydání

Bristol

Místo konání akce

Pavlov

Datum konání akce

4. 9. 2023

Typ akce podle státní příslušnosti

EUR - Evropská akce

Kód UT WoS článku

—