Difficulties of heat transfer from PCM type board to ambient room

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F70883521%3A28140%2F15%3A43873217" target="_blank" >RIV/70883521:28140/15:43873217 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Difficulties of heat transfer from PCM type board to ambient room

Popis výsledku v původním jazyce

In this article authors present results of the research performed on the thermal storage panel based on the phase change material (PCM) in conventional climatic conditions for the interior of the building. The research was performed on accumulation panels, which are installed in the laboratory of Integrated systems in buildings on Faculty of Applied Informatics, Tomas Bata University in Zlin. Heat foils were used as heating source for accumulation panels. These foils use energy produced by photovoltaicpanels and provide low cost source for heating, other option for heating is water pipe exchanger that is installed inside the panels. Water pipe exchanger can provide cooling of panels, which use cooled water by Peltier elements or heat pump. Purpose ofthe research was to make measurement of thermal behavior while panel is cooled or heated in order to obtain important accumulation parameters and heat transfer parameters from the surface of the panel. Use of the panel is tied with regula

Název v anglickém jazyce

Difficulties of heat transfer from PCM type board to ambient room

Popis výsledku anglicky

In this article authors present results of the research performed on the thermal storage panel based on the phase change material (PCM) in conventional climatic conditions for the interior of the building. The research was performed on accumulation panels, which are installed in the laboratory of Integrated systems in buildings on Faculty of Applied Informatics, Tomas Bata University in Zlin. Heat foils were used as heating source for accumulation panels. These foils use energy produced by photovoltaicpanels and provide low cost source for heating, other option for heating is water pipe exchanger that is installed inside the panels. Water pipe exchanger can provide cooling of panels, which use cooled water by Peltier elements or heat pump. Purpose ofthe research was to make measurement of thermal behavior while panel is cooled or heated in order to obtain important accumulation parameters and heat transfer parameters from the surface of the panel. Use of the panel is tied with regula

Druh

D - Stať ve sborníku

CEP obor

JE - Nejaderná energetika, spotřeba a užití energie

OECD FORD obor

—

Projekt

<a href="/cs/project/ED2.1.00%2F03.0089" target="_blank" >ED2.1.00/03.0089: Centrum bezpečnostních, informačních a pokročilých technologií (CEBIA-Tech)</a><br>

Návaznosti

P - Projekt vyzkumu a vyvoje financovany z verejnych zdroju (s odkazem do CEP)<br>S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2015

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

Advanced building skins

ISBN

9783981205381

ISSN

—

e-ISSN

—

Počet stran výsledku

6

Strana od-do

667-672

Název nakladatele

Economic Forum

Místo vydání

Munich

Místo konání akce

Bern

Datum konání akce

3. 11. 2015

Typ akce podle státní příslušnosti

WRD - Celosvětová akce

Kód UT WoS článku

—