Possibilities of replacement of two side metal molds for the production of two facing side composite by one side mold

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F70883521%3A28610%2F16%3A43874574" target="_blank" >RIV/70883521:28610/16:43874574 - isvavai.cz</a>

Nalezeny alternativní kódy

RIV/70883521:28110/16:43874574

Výsledek na webu

<a href="http://journal.strojirenskatechnologie.cz/templates/obalky_casopis/XVI_2016-3.pdf" target="_blank" >http://journal.strojirenskatechnologie.cz/templates/obalky_casopis/XVI_2016-3.pdf</a>

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Possibilities of replacement of two side metal molds for the production of two facing side composite by one side mold

Popis výsledku v původním jazyce

Presented research paper deals with possibilities of replacement of conventional mold materials by new, unconventional. Traditionally, laminate, wood or gypsum molds (in the case of small production series) are used for the production of composite parts. Furthermore, milled aluminum molds are conventionally used only for mass production. Due to this, thin metal sheet was prepared as an unconventional production mold for manufacturing of motorbike facing part. Vacuum bagging using prepared one side mold was chosen as the most appropriate technology. Normally, two facing sides are not commonly manufactured using this technology. Because of this, possibilities to create two facing sides at areas that are not in contact with mold itself were investigated. Presented results can help manufacturing companies with their production and considerably decrease manufacturing costs due to not necessity to use two side molds.

Název v anglickém jazyce

Possibilities of replacement of two side metal molds for the production of two facing side composite by one side mold

Popis výsledku anglicky

Presented research paper deals with possibilities of replacement of conventional mold materials by new, unconventional. Traditionally, laminate, wood or gypsum molds (in the case of small production series) are used for the production of composite parts. Furthermore, milled aluminum molds are conventionally used only for mass production. Due to this, thin metal sheet was prepared as an unconventional production mold for manufacturing of motorbike facing part. Vacuum bagging using prepared one side mold was chosen as the most appropriate technology. Normally, two facing sides are not commonly manufactured using this technology. Because of this, possibilities to create two facing sides at areas that are not in contact with mold itself were investigated. Presented results can help manufacturing companies with their production and considerably decrease manufacturing costs due to not necessity to use two side molds.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JI - Kompositní materiály

OECD FORD obor

—

Projekt

—

Návaznosti

I - Institucionalni podpora na dlouhodoby koncepcni rozvoj vyzkumne organizace

Rok uplatnění

2016

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufacturing Technology

ISSN

1213-2489

e-ISSN

—

Svazek periodika

16

Číslo periodika v rámci svazku

3

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

4

Strana od-do

558-561

Kód UT WoS článku

—

EID výsledku v databázi Scopus

2-s2.0-84974534209