SURFACE WAVINESS OF MEDIUM-DENSITY FIBERBOARD AND EDGE-GLUED PANEL AFTER EDGE MILLING

Result code in IS VaVaI
<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F60460709%3A41320%2F17%3A74856" target="_blank" >RIV/60460709:41320/17:74856 - isvavai.cz</a>
Result on the web
—
DOI - Digital Object Identifier
—

Result language
angličtina
Original language name
SURFACE WAVINESS OF MEDIUM-DENSITY FIBERBOARD AND EDGE-GLUED PANEL AFTER EDGE MILLING
Original language description
This article deal with investigation of mean arithmetic deviation of the waviness profile (Wa) on edge surface after edge milling of medium-density fiberboard, medium-density fiberboard with single-sided lamination and spruce edge-glued panel. Edge milling afftected feed rate 4, 8, and 11 m.min(-1) and cutting speed 20, 30, 40 a 60 m.s(-1). There were used for milling 3 types of tungsteen carbide blades with different composition and treatment (HW1, HW2 and HW1 + CrTiN coating). Working results show that the lowest values of waviness were found with a spruce glulam. Considering the machined surface quality the most suitable blade is HW1, then HW1 + CrTiN coating and the worst one is HW2. The lowest measured values of Wa were found with the feed rate of 4 m.min(-1) and cutting speed of 60 m.s(-1). The increase in cutting speed resulted in the drop in the values of average Wa, while the increase in feed rate had the opposite effect.
Czech name
—
Czech description
—

Type
J<sub>imp</sub> - Article in a specialist periodical, which is included in the Web of Science database
CEP classification
—
OECD FORD branch
20502 - Paper and wood

Publication year
2017
Confidentiality
S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Similar results(10)