Semiconducting p-Type Copper Iron Oxide Thin Films Deposited by Hybrid Reactive-HiPIMS plus ECWR and Reactive-HiPIMS Magnetron Plasma System

Result code in IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F60461373%3A22310%2F20%3A43921036" target="_blank" >RIV/60461373:22310/20:43921036 - isvavai.cz</a>

Alternative codes found

RIV/68378271:_____/20:00531792

Result on the web

<a href="https://www.mdpi.com/2079-6412/10/3/232" target="_blank" >https://www.mdpi.com/2079-6412/10/3/232</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.3390/coatings10030232" target="_blank" >10.3390/coatings10030232</a>

Result language

angličtina

Original language name

Semiconducting p-Type Copper Iron Oxide Thin Films Deposited by Hybrid Reactive-HiPIMS plus ECWR and Reactive-HiPIMS Magnetron Plasma System

Original language description

A reactive high-power impulse magnetron sputtering (r-HiPIMS) and a reactive high-power impulse magnetron sputtering combined with electron cyclotron wave resonance plasma source (r-HiPIMS + ECWR) were used for the deposition of p-type CuFexOy thin films on glass with SnO2F conductive layer (FTO). The aim of this work was to deposit CuFexOy films with different atomic ratio of Cu and Fe atoms contained in the films by these two reactive sputtering methods and find deposition conditions that lead to growth of films with maximum amount of delafossite phase CuFeO2. Deposited copper iron oxide films were subjected to photoelectrochemical measurement in cathodic region in order to test the possibility of application of these films as photocathodes in solar hydrogen production. The time stability of the deposited films during photoelectrochemical measurement was evaluated. In the system r-HiPIMS + ECWR, an additional plasma source based on special modification of inductively coupled plasma, which works with an electron cyclotron wave resonance ECWR, was used for further enhancement of plasma density ne and electron temperature T-e at the substrate during the reactive sputtering deposition process. A radio frequency (RF) planar probe was used for the determination of time evolution of ion flux density i(ionflux) at the position of the substrate during the discharge pulses. Special modification of this probe to fast sweep the probe system made it possible to determine the time evolution of the tail electron temperature T-e at energies around floating potential V-fl and the time evolution of ion concentration n(i). This plasma diagnostics was done at particular deposition conditions in pure r-HiPIMS plasma and in r-HiPIMS with additional ECWR plasma. Generally, it was found that the obtained ion flux density i(ionflux) and the tail electron temperature T-e were systematically higher in case of r-HiPIMS + ECWR plasma than in pure r-HiPIMS during the active part of discharge pulses. Furthermore, in case of hybrid discharge plasma excitation, r-HiPIMS + ECWR plasma has also constant plasma density all the time between active discharge pulses n(i) approximate to 7 x 10(16) m(-3) and electron temperature T-e approximate to 4 eV, on the contrary in pure r-HiPIMS n(i) and T-e were negligible during the &quot;OFF&quot; time between active discharge pulses. CuFexOy thin films with different atomic ration of Cu/Fe were deposited at different conditions and various crystal structures were achieved after annealing in air, in argon and in vacuum. Photocurrents in cathodic region for different achieved crystal structures were observed by chopped light linear voltammetry and material stability by chronoamperometry under simulated solar light and X-ray diffraction (XRD). Optimization of depositions conditions results in the desired Cu/Fe ratio in deposited films. Optimized r-HiPIMS and r-HiPIMS + ECWR plasma deposition at 500 degrees C together with post deposition heat treatment at 650 degrees C in vacuum is essential for the formation of stable and photoactive CuFeO2 phase.

Czech name

—

Czech description

—

Type

J_imp - Article in a specialist periodical, which is included in the Web of Science database

CEP classification

—

OECD FORD branch

10305 - Fluids and plasma physics (including surface physics)

Project

Result was created during the realization of more than one project. More information in the Projects tab.

Continuities

P - Projekt vyzkumu a vyvoje financovany z verejnych zdroju (s odkazem do CEP)

Publication year

2020

Confidentiality

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Name of the periodical

Coatings

ISSN

2079-6412

e-ISSN

—

Volume of the periodical

10

Issue of the periodical within the volume

3

Country of publishing house

CH - SWITZERLAND

Number of pages

14

Pages from-to

—

UT code for WoS article

000524211800037

EID of the result in the Scopus database

2-s2.0-85083043387