The laboratory setup for calibrating of the surface temperature sensors

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F00177016%3A_____%2F10%3A%230000478" target="_blank" >RIV/00177016:_____/10:#0000478 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

The laboratory setup for calibrating of the surface temperature sensors

Popis výsledku v původním jazyce

The calibration of the surface temperature sensors depends on number of influencing parameters including the calibrated sensor, design of the surface, ambient environment and methods of the calibration. The results also often depend on the operator experiences. In this article will be presented the laboratory setup for surface temperature calibration at ČMI. The design is based on the block of compact material with 4pc of industrial platinum resistance thermometers (IPRT) to measure the temperature gradient along the block. These measurements were used for extrapolation of the surface temperature. In the experimental part will be showed the comparison of this block with the commercial system used at ČMI. It will be also shown the influence of differentblock materials and different designs to the results. The investigation on the external environment was made. The results were compared with numerical analysis and the uncertainty budged will be presented.

Název v anglickém jazyce

The laboratory setup for calibrating of the surface temperature sensors

Popis výsledku anglicky

The calibration of the surface temperature sensors depends on number of influencing parameters including the calibrated sensor, design of the surface, ambient environment and methods of the calibration. The results also often depend on the operator experiences. In this article will be presented the laboratory setup for surface temperature calibration at ČMI. The design is based on the block of compact material with 4pc of industrial platinum resistance thermometers (IPRT) to measure the temperature gradient along the block. These measurements were used for extrapolation of the surface temperature. In the experimental part will be showed the comparison of this block with the commercial system used at ČMI. It will be also shown the influence of differentblock materials and different designs to the results. The investigation on the external environment was made. The results were compared with numerical analysis and the uncertainty budged will be presented.

Druh

D - Stať ve sborníku

CEP obor

BJ - Termodynamika

OECD FORD obor

—

Projekt

—

Návaznosti

V - Vyzkumna aktivita podporovana z jinych verejnych zdroju

Rok uplatnění

2010

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

Tempmeko

ISBN

978-961-243-146-4

ISSN

—

e-ISSN

—

Počet stran výsledku

1

Strana od-do

251-251

Název nakladatele

IMEKO TC 12

Místo vydání

Portorož

Místo konání akce

Portorož

Datum konání akce

1. 1. 2010

Typ akce podle státní příslušnosti

WRD - Celosvětová akce

Kód UT WoS článku

—