Surface sheets morphology during its division using conventional and unconventional technologies

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F00216305%3A26210%2F15%3APU114703" target="_blank" >RIV/00216305:26210/15:PU114703 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Surface sheets morphology during its division using conventional and unconventional technologies

Popis výsledku v původním jazyce

This article is about the morphology problems on the surface of the steel sheet from corrosion resistant material. The conventional character technology used was cutting technology according to tables shears NTE3150/6.3.The following technology to treatone of the cut edges was milling technology. As a comparative technology was chosen wire method EDM (Electrical Discharge Machining) cutting. The surface morphology was compared after the next manufacturing operation which was bending, during different bending radius. Bends were performed on a special fixture with the possibility of setting bend radius step by step.

Název v anglickém jazyce

Surface sheets morphology during its division using conventional and unconventional technologies

Popis výsledku anglicky

This article is about the morphology problems on the surface of the steel sheet from corrosion resistant material. The conventional character technology used was cutting technology according to tables shears NTE3150/6.3.The following technology to treatone of the cut edges was milling technology. As a comparative technology was chosen wire method EDM (Electrical Discharge Machining) cutting. The surface morphology was compared after the next manufacturing operation which was bending, during different bending radius. Bends were performed on a special fixture with the possibility of setting bend radius step by step.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JQ - Strojní zařízení a nástroje

OECD FORD obor

—

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2015

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Journal for technology of plasticity

ISSN

0354-3870

e-ISSN

—

Svazek periodika

40

Číslo periodika v rámci svazku

1

Stát vydavatele periodika

RS - Srbská republika

Počet stran výsledku

8

Strana od-do

13-21

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—