Influence of the cutting edge radius and the cutting edge preparation on tool life and cutting forces at inserts with wiper geometry

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F49777513%3A23210%2F14%3A43922223" target="_blank" >RIV/49777513:23210/14:43922223 - isvavai.cz</a>

Výsledek na webu

<a href="http://dx.doi.org/10.1016/j.proeng.2014.03.027" target="_blank" >http://dx.doi.org/10.1016/j.proeng.2014.03.027</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.1016/j.proeng.2014.03.027" target="_blank" >10.1016/j.proeng.2014.03.027</a>

Jazyk výsledku

angličtina

Název v původním jazyce

Influence of the cutting edge radius and the cutting edge preparation on tool life and cutting forces at inserts with wiper geometry

Popis výsledku v původním jazyce

This article deals with the influence of cutting edge preparation and cutting edge radius on tool life, cutting forces and the roughness of machined surface. The cutting edge preparation was done on the inserts with wiper geometry which are used during machining of dividing plane at a steam turbine casing. This cutting inserts were prepared by the technology of grinding, drag finishing and laser technology. The edge radius for drag finished tools was 5, 10 and 15mým and for laser treated tool 5mým. Theworkpiece material was ferrite - martensite steel with the content of 9%Mo and 1%Cr and the material of cutting inserts was submicron sintered carbide. There was used only one cutting insert in the milling cutter.

Název v anglickém jazyce

Influence of the cutting edge radius and the cutting edge preparation on tool life and cutting forces at inserts with wiper geometry

Popis výsledku anglicky

This article deals with the influence of cutting edge preparation and cutting edge radius on tool life, cutting forces and the roughness of machined surface. The cutting edge preparation was done on the inserts with wiper geometry which are used during machining of dividing plane at a steam turbine casing. This cutting inserts were prepared by the technology of grinding, drag finishing and laser technology. The edge radius for drag finished tools was 5, 10 and 15mým and for laser treated tool 5mým. Theworkpiece material was ferrite - martensite steel with the content of 9%Mo and 1%Cr and the material of cutting inserts was submicron sintered carbide. There was used only one cutting insert in the milling cutter.

Druh

D - Stať ve sborníku

CEP obor

JR - Ostatní strojírenství

OECD FORD obor

—

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2014

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

Procedia Engineering

ISBN

—

ISSN

1877-7058

e-ISSN

—

Počet stran výsledku

9

Strana od-do

565-573

Název nakladatele

Elsevier

Místo vydání

Vienna

Místo konání akce

Zadar

Datum konání akce

23. 10. 2013

Typ akce podle státní příslušnosti

WRD - Celosvětová akce

Kód UT WoS článku

000335859300076