Influence of Chemical Additives and Curing Conditions on Mechanical Properties and Carbonation Resistance of Alkali Activated Slag Composites
Identifikátory výsledku
Kód výsledku v IS VaVaI
<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F00216305%3A26210%2F15%3APU116060" target="_blank" >RIV/00216305:26210/15:PU116060 - isvavai.cz</a>
Výsledek na webu
—
DOI - Digital Object Identifier
—
Alternativní jazyky
Jazyk výsledku
angličtina
Název v původním jazyce
Influence of Chemical Additives and Curing Conditions on Mechanical Properties and Carbonation Resistance of Alkali Activated Slag Composites
Popis výsledku v původním jazyce
The main aim of the presented work is to investigate the effect of the addition of air entraining (AEA) and shrinkage reducing agents (SRA) on mechanical properties and carbonation resistance of alkali activated slag (AAS). Materials for the sample preparation were blast furnace slag activated using sodium silicate and AEA or SRA varying in content. Curing of samples was carried out in various conditions (air curing at laboratory conditions and water curing at the same temperature) and influence of these was studied too. The prepared samples (specimens with dimensions of 100 mm x 20 mm x 20 mm) where tested on compressive and bending strengths. The experimental results have shown that the addition of AEA had not significant influence on the mechanicalproperties while the addition of SRA had negative effect. However, the carbonation resistance markedly decreases with increasing amount of both agents. The same stands for the air curing as mechanical strengths are lower compared to those
Název v anglickém jazyce
Influence of Chemical Additives and Curing Conditions on Mechanical Properties and Carbonation Resistance of Alkali Activated Slag Composites
Popis výsledku anglicky
The main aim of the presented work is to investigate the effect of the addition of air entraining (AEA) and shrinkage reducing agents (SRA) on mechanical properties and carbonation resistance of alkali activated slag (AAS). Materials for the sample preparation were blast furnace slag activated using sodium silicate and AEA or SRA varying in content. Curing of samples was carried out in various conditions (air curing at laboratory conditions and water curing at the same temperature) and influence of these was studied too. The prepared samples (specimens with dimensions of 100 mm x 20 mm x 20 mm) where tested on compressive and bending strengths. The experimental results have shown that the addition of AEA had not significant influence on the mechanicalproperties while the addition of SRA had negative effect. However, the carbonation resistance markedly decreases with increasing amount of both agents. The same stands for the air curing as mechanical strengths are lower compared to those
Klasifikace
Druh
O - Ostatní výsledky
CEP obor
JI - Kompositní materiály
OECD FORD obor
—
Návaznosti výsledku
Projekt
Výsledek vznikl pri realizaci vícero projektů. Více informací v záložce Projekty.
Návaznosti
P - Projekt vyzkumu a vyvoje financovany z verejnych zdroju (s odkazem do CEP)
Ostatní
Rok uplatnění
2015
Kód důvěrnosti údajů
S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů