Quality of aluminium alloy surface after WEDM

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F00216305%3A26210%2F17%3APU122583" target="_blank" >RIV/00216305:26210/17:PU122583 - isvavai.cz</a>

Výsledek na webu

<a href="http://www.mmscience.eu/content/file/archives/MM_Science_2016106.pdf" target="_blank" >http://www.mmscience.eu/content/file/archives/MM_Science_2016106.pdf</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.17973/MMSJ.2017_02_2016106" target="_blank" >10.17973/MMSJ.2017_02_2016106</a>

Jazyk výsledku

angličtina

Název v původním jazyce

Quality of aluminium alloy surface after WEDM

Popis výsledku v původním jazyce

Efficient machining using wire electrical discharge machining (WEDM) technology is a compromise between cutting speed and resulting surface quality. Typical morphology of the surface machined by WEDM shows a plenty of craters caused by electrospark discharges produced during the cutting process. This work is focused on assessing the impact of machine setting parameters on quantitative and qualitative evaluation of the workpiece surface of aluminium alloy AlZn6Mg2Cu. Using metallography, the surface effects arisen during the process of wire spark erosion on cross-sections of preparations were studied. Using local spot EDX microanalysis, the chemical composition of the surfaces of the samples was studied. The attention was also paid to the highest height of profile of the craters, which were studied using 3D filtered images.

Název v anglickém jazyce

Quality of aluminium alloy surface after WEDM

Popis výsledku anglicky

Efficient machining using wire electrical discharge machining (WEDM) technology is a compromise between cutting speed and resulting surface quality. Typical morphology of the surface machined by WEDM shows a plenty of craters caused by electrospark discharges produced during the cutting process. This work is focused on assessing the impact of machine setting parameters on quantitative and qualitative evaluation of the workpiece surface of aluminium alloy AlZn6Mg2Cu. Using metallography, the surface effects arisen during the process of wire spark erosion on cross-sections of preparations were studied. Using local spot EDX microanalysis, the chemical composition of the surfaces of the samples was studied. The attention was also paid to the highest height of profile of the craters, which were studied using 3D filtered images.

Druh

J_SC - Článek v periodiku v databázi SCOPUS

CEP obor

—

OECD FORD obor

20301 - Mechanical engineering

Projekt

Výsledek vznikl pri realizaci vícero projektů. Více informací v záložce Projekty.

Návaznosti

P - Projekt vyzkumu a vyvoje financovany z verejnych zdroju (s odkazem do CEP)

Rok uplatnění

2017

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

MM Science Journal

ISSN

1803-1269

e-ISSN

1805-0476

Svazek periodika

2017

Číslo periodika v rámci svazku

1

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

4

Strana od-do

1679-1682

Kód UT WoS článku

—

EID výsledku v databázi Scopus

2-s2.0-85012005438