Effect of wirefeed rate on the morphology of a surface machined using WEDM

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F44555601%3A13420%2F16%3A43888364" target="_blank" >RIV/44555601:13420/16:43888364 - isvavai.cz</a>

Nalezeny alternativní kódy

RIV/00216305:26210/16:PU119564

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Effect of wirefeed rate on the morphology of a surface machined using WEDM

Popis výsledku v původním jazyce

Wire electrical discharge machining (WEDM) is an unconventional technology of machining that uses phys-ical phenomena for material cutting. During wire electrical discharge machining craters are formed on the workpiece surface, and blended and molten material of both workpiece and wire electrode get stuck here due to diffusion processes. The study deals with the assessment of the influence of wire feed rate on quantita-tive and qualitative evaluations of craters on the workpiece made of X155CrVMo12-1 alloy tool steel. The diffusion phenomena that had occurred on the surface during the process of cutting were studied using light microscopy. Attention was also given to the detail study of the used brass electrode where the level of wear and degradation in terms of the quality of morphology were studied after the process of cutting.

Název v anglickém jazyce

Effect of wirefeed rate on the morphology of a surface machined using WEDM

Popis výsledku anglicky

Wire electrical discharge machining (WEDM) is an unconventional technology of machining that uses phys-ical phenomena for material cutting. During wire electrical discharge machining craters are formed on the workpiece surface, and blended and molten material of both workpiece and wire electrode get stuck here due to diffusion processes. The study deals with the assessment of the influence of wire feed rate on quantita-tive and qualitative evaluations of craters on the workpiece made of X155CrVMo12-1 alloy tool steel. The diffusion phenomena that had occurred on the surface during the process of cutting were studied using light microscopy. Attention was also given to the detail study of the used brass electrode where the level of wear and degradation in terms of the quality of morphology were studied after the process of cutting.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JG - Hutnictví, kovové materiály

OECD FORD obor

—

Projekt

Výsledek vznikl pri realizaci vícero projektů. Více informací v záložce Projekty.

Návaznosti

V - Vyzkumna aktivita podporovana z jinych verejnych zdroju

Rok uplatnění

2016

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufacturing Technology

ISSN

1213-2489

e-ISSN

—

Svazek periodika

16

Číslo periodika v rámci svazku

4

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

5

Strana od-do

750-754

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—