LOAD CONTROL POSSIBILITIES OF EXPERIMENTAL LINEAR DRIVE

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F00216305%3A26210%2F17%3APU124132" target="_blank" >RIV/00216305:26210/17:PU124132 - isvavai.cz</a>

Výsledek na webu

<a href="http://www.mmscience.eu/content/file/archives/MM_Science_201702.pdf" target="_blank" >http://www.mmscience.eu/content/file/archives/MM_Science_201702.pdf</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.17973/MMSJ.2017_06_201702" target="_blank" >10.17973/MMSJ.2017_06_201702</a>

Jazyk výsledku

angličtina

Název v původním jazyce

LOAD CONTROL POSSIBILITIES OF EXPERIMENTAL LINEAR DRIVE

Popis výsledku v původním jazyce

The article describes a load drive extension for an existing laboratory experimental equipment for testing of linear drives with ball screw. The main aim is to simulate the static component of the load, and therefore the pneumatic actuator has been selected. The control elements (electro-pneumatic valves) and appropriate control strategies are also investigated. The experiment was performed with two valves exactly on the extended device and comprised of examining the behavior of the monitored system and basic capabilities of pressure-force regulation. The experiment set-up directly corresponds with the proposed use of this extension. The achieved results illustrate the ability of the load system to simulate primary the static forces. Finally, the adaptation and development are presented to improve not only the dynamic abilities of the loading system.

Název v anglickém jazyce

LOAD CONTROL POSSIBILITIES OF EXPERIMENTAL LINEAR DRIVE

Popis výsledku anglicky

The article describes a load drive extension for an existing laboratory experimental equipment for testing of linear drives with ball screw. The main aim is to simulate the static component of the load, and therefore the pneumatic actuator has been selected. The control elements (electro-pneumatic valves) and appropriate control strategies are also investigated. The experiment was performed with two valves exactly on the extended device and comprised of examining the behavior of the monitored system and basic capabilities of pressure-force regulation. The experiment set-up directly corresponds with the proposed use of this extension. The achieved results illustrate the ability of the load system to simulate primary the static forces. Finally, the adaptation and development are presented to improve not only the dynamic abilities of the loading system.

Druh

J_SC - Článek v periodiku v databázi SCOPUS

CEP obor

—

OECD FORD obor

20201 - Electrical and electronic engineering

Projekt

—

Návaznosti

I - Institucionalni podpora na dlouhodoby koncepcni rozvoj vyzkumne organizace

Rok uplatnění

2017

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

MM Science Journal

ISSN

1803-1269

e-ISSN

1805-0476

Svazek periodika

neuveden

Číslo periodika v rámci svazku

3

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

59

Strana od-do

1821-1824

Kód UT WoS článku

—

EID výsledku v databázi Scopus

2-s2.0-85020458506