Influence of AlSi7Mg0,3 Alloy Modification by SB on the Tool Wear

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F44555601%3A13420%2F14%3A43886229" target="_blank" >RIV/44555601:13420/14:43886229 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Influence of AlSi7Mg0,3 Alloy Modification by SB on the Tool Wear

Popis výsledku v původním jazyce

Modifying of alloys is an important part of the metallurgical process and involves the course also of alloys of aluminum, specifically the Al-Si (silumin) in our case. One of the elements that it is possible used to modi-fy for type of alloy Al-Si is antimony (Sb). This paper investigates potential impact of the modification of this element for AlSi7Mg0,3 alloy on tool wear in cutting process. Within experiments were made three casts of master alloy AlSi7Mg0, 3 without additional modification and threecasts from this ligatures that were more subsequently modified by 0.05 wt% Sb on the cast. These castings were then machined to the same cutting conditions and was assessed the resulting wear of inserts. The present experiment and analysis are part of larger research that are carried out at the Faculty of Production Technology and Management of Jan Evangelista Purkyně University in Ústí nad Labem.

Název v anglickém jazyce

Influence of AlSi7Mg0,3 Alloy Modification by SB on the Tool Wear

Popis výsledku anglicky

Modifying of alloys is an important part of the metallurgical process and involves the course also of alloys of aluminum, specifically the Al-Si (silumin) in our case. One of the elements that it is possible used to modi-fy for type of alloy Al-Si is antimony (Sb). This paper investigates potential impact of the modification of this element for AlSi7Mg0,3 alloy on tool wear in cutting process. Within experiments were made three casts of master alloy AlSi7Mg0, 3 without additional modification and threecasts from this ligatures that were more subsequently modified by 0.05 wt% Sb on the cast. These castings were then machined to the same cutting conditions and was assessed the resulting wear of inserts. The present experiment and analysis are part of larger research that are carried out at the Faculty of Production Technology and Management of Jan Evangelista Purkyně University in Ústí nad Labem.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JG - Hutnictví, kovové materiály

OECD FORD obor

—

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach<br>I - Institucionalni podpora na dlouhodoby koncepcni rozvoj vyzkumne organizace

Rok uplatnění

2014

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufacturing Technology

ISSN

1213-2489

e-ISSN

—

Svazek periodika

14

Číslo periodika v rámci svazku

1

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

5

Strana od-do

75-79

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—